mailto:mail@dlink.rumailto:support@dlink.ru
D-Link Главная
Installation Guide for D-Link models including: DIS-100G-5PSW, DIS-100G-5PSW Industrial Unmanaged Switch, Industrial Unmanaged Switch, Unmanaged Switch, Switch
D-Link DIS-100G-5PSW
File Info : application/pdf, 12 Pages, 213.97KB
DocumentDocumentD-Link
DIS-100G-5PSW
Industrial Unmanaged Switch with 4 10/100/1000Base-T PoE Ports and
1
1000Base-X SFP Port
4 10/100/1000Base-T, 1 1000Base-X SFP, QoS (4 PoE 802.3af/802.3at (30 ), PoE- 120 )
Quick Installation Guide
Information in this document is subject to change without notice. © 2018 D-Link Corporation. All rights reserved.
Package Contents
Open the shipping carton of the switch and carefully unpack its contents. The carton should contain the following items:
DIS-100G-5PSW switch DC power terminal block Wall mounting kit DIN-Rail mounting kit Quick Installation Guide
Hardware Overview
Interfaces
Interface Port 1 Ports 2-5
Description 1000Base-X SFP port 1000Base-T PoE ports
LED Indicators
Table 1
LED
Status
PoE
(Ports On green
2-5)
Off
P1
On green
Off
P2
On green
Off
Link/Act (Port On green
1)
Off
1000 (Port 1) On yellow
Off
Link/Act (Ports On green
2-5)
Blinking green
Off
Speed 2-5)
(Ports On yellow Off
DIP-switches
Description PoE is working. PoE is not working. P1 power line has power. P1 power line is disconnected or does not have power supply. P2 power line has power. P2 power line is disconnected or does not have power supply. Ethernet link is up. Ethernet link is down. SFP port 1000 Mbps connection is detected. No link or SFP port 100 Mbps connection is detected. Ethernet link is up. Ethernet link is up and there is traffic detected. Ethernet link is down. 1000 Mbps connection is detected. No link or 10/100 Mbps connection is detected.
Table 2
2
Pin Pin 1
Pin 2
State ON OFF ON OFF
Description
To enable broadcast storm rate limit.
To disable broadcast storm rate limit.
Not used.
Not used.
Table 3
Hardware Installation
DIN-Rail Mounting Mounting steps: 1. Screw the DIN-Rail bracket on with the bracket and screws in the accessory kit. 2. Hook the unit over the DIN-Rail. 3. Push the bottom of the unit towards the DIN-Rail until it snaps into place.
Figure 1 -- Mounting the switch on a DIN-Rail
Wall Mounting Screw on the wall-mount plate on with the plate and M4 screws in the accessory kit.
Figure 2 -- Attaching brackets to the switch
3
Figure 3 -- The switch with the attached wall mounting brackets
Grounding the Switch
Use the following instructions to ground the switch. Please complete these steps before powering on the switch. 1. Remove the grounding screw from the switch and place the grounding cable lug ring on top of the grounding screw opening. 2. Insert the grounding screw back into the grounding screw opening and use a screwdriver to tighten the grounding screw, securing the grounding cable to the switch. 3. Attach the terminal lug ring at the other end of the grounding cable to an appropriate grounding source. 4. Verify that the connection between the grounding connector on the switch and the grounding source is secure.
Figure 4 -- The grounding screw on the switch
Connecting to a Power Source
The switch can be powered by two power supplies (input range 48 to 58 V DC). Insert the positive and negative wires (AWG 14-26) into V+ and V- contact on the terminal block and tighten the wire-clamp screws to prevent the wires from being loosened.
4
. © 2018 D-Link Corporation. .
. , . , . . . -40 +75 °. , . ! . . / / . . , . 2 . c . 2 , 6 () 7 () , . : 9 - 2009, A - 2010, B - 2011, - 2012, D - 2013, E - 2014, F - 2015, G - 2016, H 2017, I - 2018. : 1 - , 2 - , ..., 9 - , A - , B - , - .
5
. , . - , .
DIS-100G-5PSW DIN-
1 2-5
1000Base-X SFP 1000Base-T PoE
1
PoE ( PoE .
2-5)
PoE .
P1
1 .
1 .
P2
2 .
2 .
Link/Act ( .
1)
.
1000 ( 1) 1000 /.
, 100 /.
Link/Act ( 2-5)
.
.
.
Speed ( 1000 /.
6
2-5)
DIP-
, 10/100 /.
2
1
ON
.
OFF
.
2
ON
.
OFF
.
3
DIN- DIN-. 1. DIN- . 2. DIN-. 3. DIN.
1 -- DIN-
. .
7
2 --
3 --
M4.
. . 1. , . 2. . 3. . 4. .
8
4 --
48-58 DC ( ). +/- , . , .
9
4 10/100/1000Base-T PoE 1 1000Base-X SFP
P1/P2 Link/Activity/Speed ( ) PoE
DIP-
DC: 1 ( 48 58 DC)
( IP30)
IEEE 802.3 10Base-T ( ) IEEE 802.3u 100Base-TX ( ) IEEE 802.3ab 1000Base-T ( ) IEEE 802.3z 1000Base-X IEEE 802.3az Energy Efficient Ethernet IEEE 802.3x MDI/MDIX
// IEEE 802.1p QoS: 4
10 /
Store-and-forward
. 64
7,44 Mpps
MAC
2K
Jumbo-
9
PoE
PoE
IEEE 802.3af IEEE 802.3at
PoE 2-5
PoE 120 2 (. 30 PoE)
0,5
( x x )
107 x 29 x 139
10
. MTBF
EMI EMC EMS
48-58 DC ( ( ))
131,57 ( PoE ) 4,46 ( PoE )
448,94 / ( PoE ) 15,22 / ( PoE )
25
: -40 75 °C : -40 85 °C
: 5% 95% : 5% 95%
UL/CE/FCC NEMA-TS2 EN50121-4 UL C1D2
UL61010-1, UL61010-2-201, UL C1D2
47 CFR FCC Part 15 Subpart B (Class A) ICES-003 Issue 6 (Class A)
EN61000-6-2 EN61000-6-4
EN 61000-4-2 ESD Level 3 EN 61000-4-3 RS Level 3 EN 61000-4-4 EFT Level 3 EN 61000-4-5 Surge Level 3 EN 61000-4-6 CS Level 3 EN 61000-4-8
IEC 60068-2-27 Shock IEC 60068-2-32 Freefall IEC 60068-2-6 Vibration
1 DC . 2 PoE .
11
- D-Link. D-Link . D-Link . D-Link , . . D-Link: 8-800-700-5465 : http://www.dlink.ru e-mail: support@dlink.ru : - , 114, , , , 3-, 289 , : "- " 390043, . , . , .16 .: +7 (4912) 575-305 : , , 14 .: +7 (495) 744-00-99 e-mail: mail@dlink.ru
1.0 2018-08-17
12