Joker Machine
Installation Guide for Joker Machine models including: 30-333 Indian Scout Brake Lever, 30-333, Indian Scout Brake Lever, Scout Brake Lever, Brake Lever
Indian Scout Brake Lever – Joker Machine
Joker Machine Clutch Lever Chrome - 30-332-3 | FortNine Canada
Jul 1, 2022 · Install lever to master cylinder with stock brake lever pivot pin assembly. Retighten master cylinder bar clamp if loosened using OEM torque ...
File Info : application/pdf, 1 Pages, 614.78KB
DocumentDocumentSec. 2 INDIAN SCOUT LEVER INSTALLATION Part No. 30-333 & 30-334 For technical support contact Joker Machine 2245 Kiowa Blvd N. Ste. 100, Lake Havasu City, AZ 86403 PHONE: 909-596-9690, FAX: 909-596-9693 sales@jokermachine.com, www.jokermachine.com INSTALLATION INSTRUCTIONS CLUTCH LEVER 1. Remove lever pivot pin assembly 2. Loosen clutch perch clamp and remove clutch cable from lever. BRAKE LEVER BEFORE YOU START READ THIS CAREFULLY You can make this easy or turn it into something more than you expected. If your stock lever has a piston actuator (shown below) and your Joker lever doesn't have a threaded hole (shown below), STOP and consult Joker Machine. Fixable, but requires an exchange Stock piston actuators are hard to get from Indian, so be careful not to destroy the piston actuator. · Use a 2.5mm Allen L Key. Don't use a T handle or driver until the actuator is loose. · Is a right hand thread, threaded from the piston side. · If the stock piston actuator isn't coming out, try heating the threaded area. It works and doesn't ruin the stock lever. · You can buy a piston actuator from Joker Machine if needed. 3. Install new clutch lever with stock pivot pin assembly. 4. Retighten clutch perch clamp using OEM torque spec. 5. Test clutch before riding. 1. Remove stock brake lever pivot pin assembly. (Loosening of master cylinder bar clamp may be required) 2. Remove stock piston actuator from brake lever with a 2.5 mm Allen L Key and install on Joker brake lever. NOTE: Stock piston actuators are hard to get, so be careful not to destroy piston actuator. 3. Install lever to master cylinder with stock brake lever pivot pin assembly. 4. Retighten master cylinder bar clamp if loosened using OEM torque specs. 5. Test braking before riding. PISTON ACTUATOR PIVOT PIN ASSEMBLY MADE IN USA 170802-D 170803-D 1/7/2022