Dimplex 2kW DC Ceramic Tower Heater - Electronic Controls

Important Information

THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE.

CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/ OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY

Please read the operating instructions carefully before using your product for the first time and keep them in a safe place.

• When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury to persons, including the following:
• If the appliance is damaged, check with the supplier before installation and operation.
• Do not use outdoors.
• Do not use in the immediate surroundings of a bath, shower or a swimming pool.
• Do not use this heater if it has been dropped.
• Do not use if there are visible signs of damage to the heater.
• Use this heater on a horizontal and stable surface, or fix it to the wall, as applicable.

Safety Precautions

• Do not locate the appliance immediately below a fixed socket outlet or connection box.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Do not use this appliance in series with a thermal control, a program controller, a timer or any other device that switches on the heat automatically, since a fire risk exists when the appliance is accidentally covered or displaced.
• In the event of a fault, unplug the appliance.
• Unplug the appliance when not required for long periods.
• This product is only intended for INDOOR RESIDENTIAL applications only.
• DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings.
• DO NOT route cord under furniture or appliances. Take care to position the cord away from traffic areas and where it will not be a tripping hazard.
• This appliance must not be used in a bathroom.
• Although this appliance complies with safety standards, we do not recommend its use on deep pile carpets or on long hair type of rugs.
• The appliance must be positioned so that the plug is accessible.
• If the supply cord is damaged it must be replaced by the manufacturer or service agent or a similarly qualified person in order to avoid a hazard.
• Keep the supply cord away from the front of the appliance.
• Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
• To reduce the risk of fire, keep textiles, curtains and or flammable material a minimum distance of 1m from the air outlet.
• In order to avoid overheating, DO NOT COVER the appliance. Do not place material or garments on the appliance, or obstruct the air circulation around the appliance, for instance by curtains or furniture, as this could cause overheating and a fire risk.
• In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
• Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.

WARNING - KEEP BATTERIES OUT OF REACH OF CHILDREN

• Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns and potential perforation of the oesophagus.
• If you suspect your child has swallowed or inserted a button battery immediately call the 24-hour Poisons Information Centre on 13 11 26 (in Australia) or 0800 764 766 (in New Zealand) for fast, expert advice.
• Examine devices and make sure the battery compartment is correctly secured, e.g. that the screw or other mechanical fastener is tightened. Do not use if the compartment is not secure.
• Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous.

⚠️ [Warning symbol] ? [Prohibited symbol] Battery compartment security [➕] Positive terminal indicator

Prohibited Usage

• ? Exposed to the weather outdoors
• ? Near water
• ? If the power cable wires are frayed or cut
• ? Where small children may be left unattended
• ? If an extension lead may become overloaded
• ? Where the power cable may be damaged
• ? On a slope or uneven surface
• ? Where there is risk of fire or close to a naked flame
• ? Where it may be damaged by chemicals
• ? Where there is a risk of interference by foreign objects
• ? This product is not made for DIY repair
• ? If there is a risk of water falling on the unit

Specifications

For greater precision, please always refer to the rating label placed on the product.

Parts Identification

The heater includes a carry handle, air outlet, control panel, and air inlet. The remote control is separate. The power cord and power switch are also visible.

[Diagram description: A diagram shows the tower heater with labels pointing to the carry handle at the top, the air outlet grille, the control panel on the front base, and the air inlet grille on the rear base. A separate diagram shows the remote control. The power cord and a separate power switch are also depicted.]

Control Panel

The control panel features an LED display and various buttons:

• Fan only
• Low power
• High power
• LED display
• Decrease (-) button
• Increase (+) button
• On/Off button
• Power button
• Timer button
• Oscillation button

[Diagram description: A close-up of the control panel shows icons and labels for fan-only mode, low and high power settings, an LED display, decrease and increase buttons, an on/off button, a power button, a timer button, and an oscillation button.]

Safety Features

Tilt Switch

The tilt switch will prevent the heater from working if it is accidentally tipped over on its side. If the radiator is tipped over while it is hot, disconnect the power and allow it to cool, then stand the radiator back upright. Reconnect the power - normal operation should be resumed.

Overheat Protection

The heater is fitted with a temperature limiter which will turn OFF the heater should it overheat for any reason. The product will return to normal operation after the cause of the overheating has been rectified.

Operation

IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE PLACED ON THIS HEATER.

Before using the heater ensure that all warnings and instructions have been read carefully. To begin using the heater simply plug it in to a corresponding power outlet.

1. Turn on the main power switch at the back of the unit to the 'I' [ON symbol] position. The unit will beep once to indicate it is powered and in standby mode. The LED display will illuminate and indicate the current room temperature.
2. Press the On/Off button to turn the unit ON.
3. Press the POWER button once to operate in low power (1200W) or twice to operate in high power (2000W). The corresponding low and high power indicator light will illuminate on the control panel.
4. A TIMER can be set up to 12 hours, so the unit turns OFF automatically after a set period. Press the TIMER button and cycle through, in 1 hour increments, the desired time. The set time will flash on the LED Display. To cancel the TIMER, cycle through until '0' shows on the display.
5. To adjust the room temperature, set the desired temperature between 10-35°C. The temperature is set in 1°C increments and will flash on the LED display until selected. The unit will automatically work to reach and maintain the set temperature.
6. The unit is equipped with an oscillating base. To activate, press the OSCILLATION button. Press again to cancel.
7. Press the power On/Off button to turn the unit OFF. It takes approx. 30 seconds for the unit to power OFF, this is to protect the heating element.
8. If the unit isn't being used for an extended period of time, switch the main power switch to '0' [OFF symbol] (after the unit has turned OFF completely which takes approx. 30-60 seconds).

Remote Control

The remote control performs the same settings as the control panel on the unit. Simply follow the same operation instructions mentioned previously.

The remote requires 1 x CR2025 3v lithium battery.

1. Open the battery compartment (see Fig. 1).
2. Insert the battery into the remote control compartment.
3. Close the battery compartment.

[Diagram description: Figure 1 shows the battery compartment of the remote control. It indicates the CR2025 battery, the positive (+) terminal, and the direction for opening (PUSH).]

Cleaning

Over time, dust can accumulate on the heater which can affect performance. It is recommended to clean the unit at least once a month.

1. Turn the unit OFF and disconnect the appliance from the power supply.
2. Remove any dust build up with a soft brush.
3. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used for any stubborn marks.

IMPORTANT: The control panel and other parts must not come into contact with water or any other liquids.

Storage

If not using the unit for an extended period of time. After cleaning please:

• Ensure control switch is OFF and remove plug from the power outlet.
• Cover the unit and store it upright in a location where it will not receive direct sunlight. NB- Prolonged exposure to direct sunlight will discolour the unit.

Maintenance and Warranty

If the unit fails to operate efficiently, is broken or other problems arise, unplug and do not operate. Ask for advice by calling your local after sales service agent or the Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ).

Please refer to the warranty card in the box for warranty information. For any troubleshooting advice, please contact the relative Customer Care Centre below.

Glen Dimplex Australia Pty Ltd

1340 Ferntree Gully Road, Scoresby 3179, Victoria, Australia

Ph: 1300 556 816

Glen Dimplex New Zealand Ltd

38 Harris Road, East Tamaki, Auckland 2013, New Zealand

Ph: 0800 666 2824

♻️ [Recycling symbol] Recycling: Do not dispose of electrical appliances as unsorted municipal waste. Use separate collection facilities. Contact your local government for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the ground water, polluting the food chain and damaging health and well-being.

Contact Information

Customer Care: 1300 556 816

Email: customer.care@glendimplex.com.au

Website: www.dimplex.com.au

Supplied by Glen Dimplex Australia

1340 Ferntree Gully Road, Scoresby, Victoria, 3179