Govee Glide Wall Light Quick Start Guide

Watch The Installation Video Tutorial

For a visual guide, please:

• Visit the Govee Glide Wall Light product page on store.govee.com
• Search "Govee Glide Wall Light" on Amazon or YouTube.

Caution

• Do not power on until you have assembled all segments.
• This product is ideally used on smooth surfaces (e.g., glass, wood, etc); it is not suitable for uneven, bumpy, or wet surfaces (e.g., brick, stucco, etc).
• Keep the product away from water. If you need to clean it, please use a dry rag.
• Clean and ensure the surface is totally dry before sticking the product on.

In the Box

• 6 Segments (30cm each)
• 1 Corner Piece
• 1 Control Box and Input Cable
• 1 Power Adapter

Before Installation

Step 1: Assemble Segments

Assemble the segments with the desired layout on a flat surface. Press down firmly until the segments "snap" into place. This step involves connecting the individual light segments end-to-end to form the desired shape.

Diagram Description: Shows individual light segments and a corner piece being connected. A close-up illustrates pressing two segments together until they lock.

Step 2: Connect Input and Power

Connect the input cable from the control box to the end segment or corner piece. Then, connect the control box to the power adapter.

Diagram Description: Illustrates connecting the input cable to the end of the assembled light segments and connecting the control box to the power adapter.

Step 3: Test and Prepare for Mounting

Power on the light to check if each segment is working correctly. After testing, power off the light, disassemble the segments, and disconnect the control box. This step is for initial verification before permanent installation.

Diagram Description: Shows the assembled light strip powered on, indicating functionality. Then shows the components being disconnected in preparation for wall mounting.

Installation Steps

Step 4: Plan Installation Location

Plan the appropriate installation location in advance. Determine the position of the outlet. It is recommended to place the control box and adapter close to the outlet for convenience. Consider the overall dimensions, with segments typically being 30cm and a potential total length of 300cm.

Diagram Description: Shows a wall with an electrical outlet. It illustrates planning the layout of the light segments, control box, and power adapter, positioning them near the outlet. Dimensions like 35cm, 30cm, and 300cm are indicated.

Step 1: Mount Segments to Wall

Install the segments starting from the side farthest away from the power adapter. When installing, remove the protective film from the adhesive backing on each segment. Push each segment firmly against the wall for at least 30 seconds to ensure a secure bond. The numbering (1 through 6) indicates the order of attachment.

Diagram Description: Depicts segments being attached to a wall. It shows removing a protective film from the adhesive strip on the back of a segment and pressing it firmly to the wall. A sequence of numbered steps (1-6) shows the order of segment attachment.

Step 2: Final Connections

After all segments are assembled and mounted on the wall, connect the input cable from the control box to the end segment. Finally, connect the control box to the power adapter and plug it into the outlet.

Diagram Description: Shows the light segments attached to the wall. It illustrates connecting the control box wire to the last segment and then connecting the control box to the power adapter.

To Disassemble

To remove the light, gently pull to detach the segments from each other. Then, carefully peel off the adhesive tape from the wall. A close-up view shows how to detach one segment from another.

Diagram Description: Illustrates the process of disassembling the light segments by pulling them apart. It also shows removing the adhesive tape from the wall surface. A magnified view highlights the detachment mechanism between segments.