Instructions for FOUNDER models including: RF7K-1CH-M-DO, RF7K-1CH-M-DO Remote Control Unit, Remote Control Unit, Control Unit, Unit
Shenzhen Founder Industrial Co., Ltd RF7K RF Remote control unit 2BKEO-RF7K 2BKEORF7K rf7k
Customer information Model: RF7K-1CH-M/DO Safety hints The appliance is suitable for led desk lamp. The appliance is suitable for tropical climates only. The maximum ambient temperature during use of the appliance must not exceed 75C. Naked flame sources, such as candles, must not be placed on the appliance. If the appliance can't work,please check whether the button battery is out of charge and replace it with a new one. Remove the plastic slice first,or it won't work. The maximum distance between remoter and receiver is more than 15 meters.The closer distance,the better effect.The remoter singal can pass through the non-metallic barrier,such as wall and plastic shell.. Pair the controller and receiver,then the receiver can only be controlled by the paired controller. The appliance does not require much attention. If you want to clean it, please use only dry cloths or a brush. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. Symbols used: Protection class II appliance The appliance shall not be disposed together with the normal waste. It must be recycled. Indoor use only Manufacturer: Shenzhen Founder Industrial Co., Ltd 3rd Floor,Building B,No.65 Chuangyi Road,Gaofeng Community,Dalang Street,Longhua District,Shenzhen This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipmentMicrosoft Word 2016