User Manual for Shanghai Longqian Toys models including: JR1602, 2A8HC-JR1602, 2A8HCJR1602, JR1602FCC Remote Control, Remote Control
Shanghai Longqian Toys CO., LTD JR1602 JR1602FCC 2A8HC-JR1602 2A8HCJR1602 jr1602
JR1602 Jr1602 Fcc by Shanghai Longqian Toys
File Info : application/pdf, 2 Pages, 111.07KB
DocumentDocumentJR1602FCC Remote Control Manual (1). Supply Voltage---DC 3.0V , Battery 2*1.5V AAA (not included) (2). Frequency 2.407GHz-2.473GHz (3). Instructions a. First time use need to match code, this product has memory function c. Turn on the car body power nowThe first LED lit up, Match code Success e. Keys caption " " Forward, " P " Brake. d. Remoter 10 seconds not run will be standby ,Press any key wake up " " Back," " Left," " Right, " S "Speed, Press " S " key set up speed , 1 led lit up is low speed2 leds lit up is medium speed 3 leds lit up is high speed, Back a car is only low speed Press " P " key hold the brake, All LED flicker Replace battery is unnecessary match code This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The remote controller only can be used with adult's guidance Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. b. Hold down " " & " " keys for 3 seconds start match code, The first LED flicker Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user's authority to operate the equipment. FCC Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help.Adobe Illustrator CS6 (Windows) Adobe PDF library 10.01