User Manual for Kaadas models including: WRK, 2AQY4-WRK, 2AQY4WRK, Smart Keypad, Keypad

U Manual

Shenzhen Kaadas Intelligent Technology Co.,Ltd WRK Smart Keypad 2AQY4-WRK 2AQY4WRK wrk

download (pdf)

WRK Smart Keypad by Shenzhen Kaadas Intelligent

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized
• Document:
  • Text

File Info : application/pdf, 4 Pages, 342.92KB

User Manual
Smart Keypad is a Bluetooth 5.0 BLE accessory as a device of lock to input key and fingerprint, The Keypad is powered by 2*AAA battery.
Pairing Mode Press and hold the "*" key for 5 seconds, until the green light blinks slowly, and the buzzer beeps shortly one time. One Touch Locking: Press and hold Any key on keypad for 2 Seconds to lcok the door. Lock-Out If you fail to unlock the door for 5 consecutive times using the PIN Key, you lock will be shut-down for 3mins.
Support
2*AAA DC 3V Bluetooth 5.0 BLE Android 6.0 and iOS 13.3 or later Indoor dry location use ONLY
Quiuick Start Guide
Preparation

1. Download the Revolo App from Google Play or App Store.
2. Successfully Added a WR Retrofit Smart lock. Pairing the Keypad 1. Go to the device to a add accessory, "Settings" -> "Accessory" -> "Add Accessories" or "+".

2. Hold the button "*" of the accessory for 5s to enter pairing mode.
3. Follow instrucions from App and accessory prompts, then complete the process. Tip: If you encounter any problems during the use of the product, please contact support@irevolo.com.

FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution! Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Canada Statement This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s).Operation is subject to the following two conditions: (1)This device may not cause interference. (2)This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage. (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.