DZS 2466GN Quick Installation Guide

Model: 2466GN

Version: V 1.0

1. Caution and Warnings

Please follow the instructions below to avoid physical injury:

Do not install the unit during a storm.
Do not connect or disconnect any line to avoid the risk of electric shock.
This unit is for indoor use only, and all communication wirings are limited to inside the building.
Do not plug in, turn on, or attempt to operate an obviously damaged unit.
Never look directly at the fiber TX port and fiber cable ends when they are powered on.
Do not use near water.
Do not place near high-temperature sources.
Do not disassemble the unit.
Do not operate the unit in a location where the maximum ambient temperature exceeds 40°C (104°F).
Open optical connections must use a protective cap under all circumstances to protect against physical damage and dirt.
Before making connections, use isopropyl alcohol and non-fibrous cellulose wipes to clean the faces of the connectors.
Avoid impact stresses when handling connectors. Physical damage to the faces of optical connections impairs transmission quality (higher attenuation).
Avoid a bend radius in excess of 30 mm for fiber optic links.
Check the available voltage supply.
Only use the unit in dry rooms.
Set up the unit away from direct sunlight or other electrical equipment.
Only connect approved accessories.
It may only be repaired by authorized service personnel.
This equipment is not suitable for use in locations where children are likely to be present.

Limited Warranty

Defects and damage resulting from product disassembly by yourself are not covered under this warranty. Such behavior may also amount to intellectual property infringement.

2. Introduction

2.1 Package Contents

2466GN Optical Network Terminal (ONT)
QIG (Quick Installation Guide)

2.2 Specification

Item	Specification
Uplink Interface	1 GPON port (SC/APC)
Service Interface	4 10/100/1000Base-T ports (RJ45)
VoIP Interface	2 FXS ports (RJ11)
Power Adapter	Output: DC12V/2A
Operating Temp.	0 to 40°C (32 to 104°F)
Operating Humidity	5 to 95% (non-condensing)
Dimensions	9.91 in (251.80 mm) x 5.83 in (148.1 mm) x 1.5 in (38.4 mm)

2.3 Interface

The DZS 2466GN features the following interfaces:

GPON Port: Connects to the optical network.
GE 1-4 Ports: Four 10/100/1000Base-T Ethernet ports for connecting PCs or LAN devices.
POTS 1-2 Ports: Two FXS ports (RJ11) for connecting VoIP phones.
USB Port: For connecting an external 3.0 USB drive.
WPS Button: Enables the Wi-Fi Protected Setup process.
RESET Button: Reboots the unit.
UPS Port: Power connector and UPS backup power input.

2.4 LED Status

The unit has various status LEDs:

Label	Light	Status	Definition
POWER	Green	ON	Normal operation on AC source.
POWER	Yellow	ON	Operating on Battery Power.
POWER	Yellow	Slow Blink (2/sec)	Battery Alarm (Low Battery, Missing or Replace).
STATUS	Green	ON	Normal Operation.
STATUS	Green	Rapid Blink (10/sec)	Unit has been reset to factory defaults / is unconfigured.
STATUS	Green	Slow Blink (1/sec)	Boot-up/ Initialization/ provisioning in progress.
ALARM	Red	ON	Major Alarm (including operating in battery power).
ALARM	Red	Slow Blink (2/sec)	SW or Config update in progress.
WAN	Green	ON	Ranged successfully.
WAN	Green	Flash (1/sec)	Ranging in progress.
WAN	Green	OFF	Not ready for ranging or not provisioned.
INTERNET	Green	ON	Internet service is available.
INTERNET	Green	OFF	Internet service is unavailable (no response from DNS server).
GE1-4	Green	ON	Ethernet interface linked.
GE1-4	Green	Flash	Data transmitting.
GE1-4	Green	OFF	Ethernet interface not linked.
VOICE	Green	ON	Registered successfully.
VOICE	Green	Slow Blink (1/sec)	Off hook.
VOICE	Green	OFF	Registration failed or telephone service is not provisioned.
USB	Green	ON	USB is connected.
USB	Green	OFF	USB is not connected.
2.4GHz	Green	ON	2.4GHz WiFi service is enabled on ONT.
2.4GHz	Green	Slow Blink (1/sec)	2.4GHz WiFi data passing between ONT and connected devices.
2.4GHz	Green	OFF	2.4GHz WiFi service is disabled on ONT.
5GHz	Green	ON	5GHz WiFi service is enabled on ONT.
5GHz	Green	Slow Blink (1/sec)	5GHz WiFi data passing between ONT and connected devices.
5GHz	Green	OFF	5GHz WiFi service is disabled on ONT.
WPS	Green	ON	WPS successful connection established (for 5 sec).
WPS	Green	Slow Blink (1/sec)	WPS in progress.
WPS	Green	OFF	Disabled or process successfully finished.

UPS Connector Pinouts

The UPS connector has 8 pins with the following functions:

Pin 1 (+VDC): Power input from UPS.
Pin 2 (-VDC): Power return to UPS.
Pin 3 (On Battery): Open signal when on battery power.
Pin 4 (Signal Return): Connected to Signal GND on ONT.
Pin 5 (Missing Battery): Open signal when battery not detected.
Pin 6 (Replace Battery): Open signal when battery should be replaced.
Pin 7 (GND): Connected to Signal GND on ONT.
Pin 8 (Low Battery): Open signal when battery is low.

3. Installation

Follow these steps to install the DZS 2466GN:

Remove the fiber service cover to expose the GPON port.
Connect the fiber optic cable with an SC/APC termination to the GPON port.
Re-attach the fiber service cover onto the 2466GN.
Connect the telco cable from the POTS port to home phone lines.
Connect the Ethernet cable from a GE port to a PC.
Connect the power cable from the power port to an electrical outlet.
(Optional) Connect the Battery Backup Unit power and telemetry to the UPS port.

Mounting on a Wall

If necessary, the ONT can be mounted on a wall using the provided mounting holes. The unit dimensions are approximately 9.91 inches (251.80 mm) in length, 5.83 inches (148.1 mm) in width, and 1.5 inches (38.4 mm) in height. Mounting hole spacing is not explicitly detailed but is indicated on the diagram.

4. Web Access

You can access the unit's configuration interface through a web browser:

Connect an Ethernet cable from your computer to the GE1 port on the 2466GN.
Launch a web browser or telnet session and navigate to the IP address 192.168.1.1.
Enter the default username and password: admin / dzsi.

For security, it is recommended to change the default password.

Regulatory Information

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) it must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, designed to provide reasonable protection against harmful interference in a residential installation. It generates, uses, and can radiate radio frequency energy. If not installed and used according to instructions, it may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation. If interference occurs, users are encouraged to correct it by reorienting or relocating the receiving antenna, increasing separation between equipment and receiver, connecting the equipment to a different circuit, or consulting a dealer or technician. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and should be installed and operated with a minimum distance of 20cm between the radiator and your body.

Industry Canada Statement

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) it must accept any interference received, including interference that may cause undesired operation. This device also complies with ICES-003 of the Industry Canada (IC) Rules. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, designed to provide reasonable protection against harmful interference in a residential installation. It generates, uses, and can radiate radio frequency energy. If not installed and used according to instructions, it may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation. If interference occurs, users are encouraged to correct it by reorienting or relocating the receiving antenna, increasing separation between equipment and receiver, connecting the equipment to a different circuit, or consulting a dealer or technician. This equipment complies with RSS-102 radiation exposure limits set forth for an uncontrolled environment and should be installed and operated with a minimum distance of 20cm between the radiator and your body.

A French version of the Industry Canada statement is also provided in the original document.

	DZS 2466GN ONT Quick Installation Guide \| Setup and Specifications Comprehensive guide to installing and configuring the DZS 2466GN Optical Network Terminal (ONT). Includes setup instructions, interface details, LED status explanations, and important safety warnings.
	DZS Helix Portfolio: Multi-Gigabit Experience for Home and Business Explore the DZS Helix portfolio, offering a comprehensive range of GPON, XGS-PON, and WiFi 6 Optical Network Terminals (ONTs), Gateways, and Access Points for residential and business broadband services. Features include advanced WiFi, Smart OMCI, and DZS Cloud EDGE software for enhanced performance and management.
	DZS 5228XG: Quick Installation and Setup Guide for Broadband Access This guide provides essential information for the installation and setup of the DZS 5228XG broadband access device, covering package contents, specifications, LED indicators, and mounting instructions.
	DZS H646GM-V GPON Gigabit ONT with Wi-Fi Service Datasheet Datasheet for the DZS H646GM-V, a GPON Gigabit ONT with Wi-Fi Service, detailing its features, protocols, interfaces, and specifications for enabling hyper-connected home networks.
	The Cloud-Orchestrated Path to CSP Ascendancy in the Emerging Metaverse Explore how Communications Service Providers (CSPs) can become Experience Providers (XPs) in the Metaverse era with DZS's Cloud Edge platform, focusing on virtualized, vendor-neutral Quality of Experience (QoE) management for enhanced customer loyalty and new revenue streams.
	DZS 2804GN FiberLAN Desktop GPON ONT: Features, Specifications, and Applications Detailed information on the DZS 2804GN FiberLAN Desktop GPON ONT, a next-generation plenum-rated PoE ONT optimized for enterprise and hospitality deployments. Covers features, benefits, service scenarios, technical specifications, and ordering information.
	DZS zNID GPON 2424A1/2426A1/2428A1 Indoor ONT Datasheet Datasheet for DZS zNID GPON 2400A1 Series Indoor GPON ONTs, including models 2424A1, 2426A1, and 2428A1. Features dual-band 802.11ac WiFi, multiple LAN ports, and VoIP capabilities for FTTH deployments.
	DZS 1764WC WiFi-6 Wireless Router Quick Start Guide A quick start guide for the DZS 1764WC WiFi-6 Wireless Router, detailing product overview, hardware features, setup instructions for single router and mesh configurations, management methods, and frequently asked questions.