User Guide for kogan models including: NBDIGMGTIMA Digital Magnetic Timer, NBDIGMGTIMA, Digital Magnetic Timer, Magnetic Timer, Timer
The volume is set to 'High' by default. • The 'Volume' button is located at the back of the timer. ... Rotate the knob to the right to increase the time and ...
DIGITAL MAGNETIC TIMER NBDIGMGTIMA OVERVIEW Screen Start/Pause Button Battery Cover Volume Button Magnets & Anti-Slip Pads Spin Button OPERATION Power On Insert x3 AAA batteries. The display will illuminate, and the timer will play an audio tone, indicating the timer is powered on. Volume · The volume is set to `High' by default. · The `Volume' button is located at the back of the timer. · Press the `Volume' button to cycle through the volume levels: High, Medium, Mute. Volume button Note: When the timer is set to mute, the timer will not produce any sound when it reaches 00:00. The screen will brighten for 5 seconds, then dim, and continue flashing for 1 minute. Countdown 1. Turn the knob to set the desired countdown time. Rotate the knob to the right to increase the time and to the left to decrease it. Turning the knob quickly, with an angle greater than 60 degrees, will adjust the minute value rapidly. Fine-tuning the seconds can be done after a 1second interval. 2. Once the time is set, press the `Start/Pause' button to start the countdown. When the countdown reaches 00:00, the timer will beep for up to 1 minute, and the screen will flash. Press the `Start/Pause' button to stop the beep. 3. During the countdown, press the `Start/Pause' button to briefly pause. When paused, press and hold `Start/Pause' button to reset the timer to 00:00. Notes: · Seconds are adjusted in 5-second increments. · During operation, the display brightness will dim after 5 seconds of no user input. · When not in use, the display brightness will dim after 5 seconds of no user input and will turn off completely after 10 seconds, entering power-saving mode. Timer When the display shows 00:00, press the `Start/Pause' button to start the timer. Press the `Start/Pause' button briefly to pause. When paused, press and hold the `Start/Pause' button to reset the timer to 00:00. Notes: · If the timer reaches 199 minutes and 59 seconds, it will beep, and the display will flash. The beep will last for up to 1 minute when the timer reaches 00:00. Press the `Start/Pause' button to stop the beep. · During operation, the display brightness will dim after 5 seconds of inactivity. Mounting Options · The base has two magnets, allowing the timer to be attached to any ferrous metal surface. · The rotating bracket can be used to place the timer on a flat surface. SPECIFICATIONS Operating voltage Operating temperature Battery life Product size Timing range Volume file Product colour Bare metal weight 4.5V (x3 AAA batteries) 0°C~50°C 3 months Diameter 78 x 26.5mm Display minutes and seconds Timing max: minutes 00~199; seconds 00~59 Mute/High 80~90DB/Medium 60~78DB Black, white 71g ± 1g NOTESAdobe PDF Library 24.3.86