3 IN 1 SOIL TESTER

Key Features

This 3-in-1 Soil Tester measures three essential factors for plant health:

• Sunlight: Assesses light levels for optimal plant growth.
• Moisture: Indicates the water content in the soil.
• pH: Measures the acidity or alkalinity of the soil.

The device features a clear readout scale for easy interpretation of measurements.

Sensors and Readout Scale

The tester is equipped with three sensors:

• Light Sensor: Measures relative light from 0-2000 lux (0-200 Low, 1000-2000 High). Helps determine if plants receive adequate light.
• Moisture Sensor: Indicates moisture levels with a range of 1-10 (1-3 Dry, 4-7 Normal, 8-10 Wet). Alerts users when to water.
• pH Sensor: Measures pH on a scale of 3.5-8 (3.5-6.5 Acidic, 7 Neutral, 7-8 Alkaline). Aids in controlling soil pH levels.

The readout scale displays:

• pH: 3.5-8
• Moisture: 1-10
• Light: 0-2000

Instructions for Use

1. Switch the selector to the desired measurement (Moisture, pH, or Light).
2. Insert the probe into the soil, approximately 2-4 inches deep.
3. Adjust the probe's position until the pointer on the dial swings slightly.
4. After 10 minutes, read the moisture, pH, or light level indicated on the dial.
5. Remove the probe from the soil and wipe it clean after each use.

Important Note: The meter will not function in dry soil. Ensure the soil is watered before taking measurements for accurate pH readings.

Product Specifications

• pH Range: 3.5-8 (3.5-6.5 Acidic, 7 Normal, 7-8 Alkaline)
• Moisture Range: 1-10 (1-3 Dry, 4-7 Normal, 8-10 Wet)
• Relative Light: 0-2000 lux (0-200 Low, 200-500 Low+, 500-1000 Normal, 1000-2000 High)
• Size: 6 x 28 x 5 cm [2.36 x 11 x 2 inches]
• Probe Length: 18cm [7.1 inches]
• Copper Probe Diameter: 4.8mm
• Aluminum Probe Diameter: 5.1mm
• Distance Between Probes: 1.2cm