Instructions for visual comfort models including: KW4115, Covet Large, Flush Mount, Mount, Flush
Jan 3, 2022 — Carefully remove all parts from the box. Place on a clean, soft surface. 2. Remove mounting plate (B) from canopy (E) by removing screws (G).
Covet Large Flush Mount
Index of /files/vc/
ASSEMBLY INSTRUCTIONS Diagram 1 Diagram 2 A B C D J E I F G H Covet Large Flush Mount Item # KW 4115 NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved. TOOLS REQUIRED (NOT INCLUDED): Phillips Screwdriver Slotted Screwdriver Drill Pencil Hammer PERSONS REQUIRED: Two 1. Carefully remove all parts from the box. Place on a clean, soft surface. 2. Remove mounting plate (B) from canopy (E) by removing screws (G). 3. Using mounting plate (B) as a guide, line up with the junction box and mark anchor positions. 4. Using a drill bit slightly smaller than the anchor, drill holes in the marked positions. Install anchors (A) into the holes using hammer. 5. Install mounting plate (B) to the junction box and secure with mounting screws (D), then secure wood screws (C) to anchors (A). 6. Run support cable through hole on back of mounting plate (C). Loosen cable lock and install to end of support cable. Insert cable through the other side of cable lock and tighten ends with a screwdriver to secure. (see diagram 1) 7. Connect the supply ground wire to the green ground screw on the mounting plate (B) and secure. (see diagram 2) NOTE: It is imperative that the fixture is grounded. 8. Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (J). 9. Connect fixture hot wire (black) to the supply hot wire (usually black) using the wire nut (J). CAUTION: Do not reverse the hot and neutral connections. M LI ST ED US ASSEMBLY INSTRUCTIONS Diagram 1 Diagram 2 A B C D J E I F G H Covet Large Flush Mount Item # KW 4115 NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved. 10. Make sure all wire connections are tight, then carefully tuck into the junction box. 11. Install canopy (E) to mounting plate (B) and secure with screws (G). NOTE: It is recommended to have a helper assist in supporting the fixture for step 12. 12. Affix shade brackets (F) to either side of alabaster shade (H), then secure to canopy (E) using screws (I). Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents. M LI ST ED USAdobe PDF library 15.00 Adobe Illustrator(R) 24.0