MagnaFlow Exhaust, Mufflers & Cat Converters - Quality. Power. Sound.
Instruction Manual for BRExhaust models including: 106-0389 Replacement Exhaust System, 106-0389, Replacement Exhaust System, Exhaust System
File Info : application/pdf, 1 Pages, 284.36KB
DocumentDocumentINSTALLATION INSTRUCTIONS | PART NO. 106-0389 BILL OF MATERIALS: 2 1 5 4 6 5 3 8 7 1. 167812 2. 168380 3. 168381 4. 167507 5. 168378 STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle's battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing. STEP 2: Attach item 3/7 (match to OE) to existing exhaust with item 1/8 (nuts and bolts not included) STEP 3: Connect item 5 to existing isolator and item 3 with item 4 STEP 4: Connect joint on item 5 with item 6 STEP 5: Reconnect sensor with item 2 (nuts not included) STEP 6: Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain. STEP 7: Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY) WARNING: When working on, under, or around any vehicle exercise caution. Please allow the vehicle's exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed. BRExhaust recommends professional installation for all products Technical Support: 1-800-631-7271 BRExhaust -- 1901 Corporate Ctr, Oceanside, CA 92056 www.brexhaust.com