GE Cync Dynamic Effects Light Strip & Extension Installation Guide

What's Included

Light Strip Contents

The GE Cync Indoor Dynamic Effects Light Strip package typically includes:

• 1 x 16ft Full Color Light Strip
• 1 x Power supply with plug
• 1 x Reconnector wire
• 6 x Mounting clips
• 1 x Cleaning wipe

Light Strip Extension Contents

The GE Cync Light Strip Extension package typically includes:

• 1 x 8ft Full Color Light Strip
• 1 x Extension cable (power supply sold separately)
• 1 x Snap connector
• 3 x Mounting clips

Note: Mounting clip designs may vary.

Easy Setup

Set up your Light Strips with three easy steps:

1. Step 1: Plug in and power on your Light Strip by pressing the On/Off button on the power supply.
2. Step 2: Download the Cync App, powered by Savant, on your smartphone.
3. Step 3: Add your smart lights to the Cync App, then connect to Hey Google or Amazon Alexa voice assistants (sold separately) within the Cync App.

Set Up in the CYNC App

Follow these steps within the Cync App:

1. Step 1: Connect to the Cync App.
2. Step 2: Trim to desired length (if applicable).
3. Step 3: Add re-connector wire to extend the strip after it is cut.

For setup help, visit cyncsupport.gelighting.com or call 1-844-302-2943.

Measure & Trim to Size

Follow these steps if you need to adjust the length of your light strip:

1. Step 1: Measure where you're planning to install your lights. If your space requires Light Strip Extensions, make sure to attach them before trimming your strips.
2. Step 2: With your Light Strip unplugged, safely cut where the trim points are indicated. ⚠️ Make sure the strip is not plugged in when cutting. Cutting anywhere else will permanently damage the strip.
3. Step 3: Add re-connector wire to extend the strip after it is cut.

Prep the Surface & Install Your Strip

Prepare your installation area:

1. Step 1: Use the cleaning wipe to remove dust from the surface. Ensure the surface is dry and free of dirt, dust, and oils. For best results, adhere the strip in temperatures above 50°F/10°C.
2. Step 2: Lay out mounting clips where desired for securing the strip.

Installing Without Adhesive

Use mounting clips for installation:

1. Step 1: Lay out mounting clips where desired.

Extend & Power On the Light Strip

Connect and power up your light strip:

1. Step 1: Connect the extension wire and power supply, then power on the light strip.

FCC Statement

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.