Instruction Manual for VIMUKUN models including: X-60, X60, 2A4PZ-X-60, 2A4PZX60, X60 Vinyl Record Player, Vinyl Record Player
GuangZhou MuGuo XinXiJiShu YouXianGongSi X-60 Record Player 2A4PZ-X-60 2A4PZX60 x 60
Instruction Manual
Problem The platter doesn't turn although the unit is switched on
No signal through one or other channel or both channels:
Strong hum on phono input:
Distorted of inconsistent sound from one or both channels
Solution
- The unit is not connected to the main power supply. - No power at the outlet. - Drive belt is not installed or has slipped off. - The unit automatically switched in standby mode, power OFF and ON again. - Amplifier or speakers muted. - No connection to the speakers. - No connection between turntable and amplifier. - Wire leads not connected to the cartridge. - No ground connection from the cartridge, arm, or arm cable to amplifier or
ground loop. - Turntable too close to speakers. - The vinyl record is damaged. - Turntable is connected to the wrong input of the amplifier. - Needle or cantilever damaged. - Drive belt overstretched or dirty. - Platter bearing without oil, dirty or damaged. - Dust on the stylus.
12
9
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Adobe PDF library 15.00 Adobe Illustrator(R) 24.0