Instruction Manual for Mossloo Industrial models including: M1025Q, 2AN8F-M1025Q, 2AN8FM1025Q, Light Up MagClick, Fast Wireless Charger Holder, Light Up MagClick Fast Wireless Charger Holder
Shenzhen Mossloo Industrial Co.,Ltd M1025Q 2AN8F-M1025Q 2AN8FM1025Q m1025q
Light up MagClick® Fast Wireless Charger/Holder 7143-51 Wireless Charging Surface Type-C Input Port Phone holder Light Up Panel / LED Indicator 1. Wireless Charging Mobile phones and other electronic devices: · Connect the provided USB to Type C cable to Type C input port (2), then connect USB tip of the cable to a power source. Light up panel / LED indicator(4) will flash WHITE three times ,and then glow WHITE to indicate the wireless charger is in standby mode and ready to begin charging. · Place the wireless charging supported mobile device on the wireless charging surface(1), LED will breath WHITE when device is charging. · Phone will begin to charge automatically. · Once fully charged remove the device. ** Note: When wireless charging, if the LED indicator flash WHITE alternately, the device is either NOT a wireless charging device or there is an object between the the device and charging surface interfering with the charging process. 2. Wireless Charging with Magnetic Surface: · If your wireless charging compatible device contains magnets, it would just click to the magnetic surface(1) of the pad for better alignment to secure wireless charging. · This item is also compatible with other items, the magnetic function just won't work. 9V/2A 12. 2021.12.16 FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC's RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.Adobe PDF library 15.00