puraflame
Owner's Manual for PuraFlame models including: EF511A, EF511A Electric Fireplace Log Set, Electric Fireplace Log Set, Fireplace Log Set, Log Set, Set
PuraFlame 24" Free Standing Electric Fireplace Log Set Insert, 750W/1500W Heater, 6 Flame Colors with 5 Brightness, Crackling Sound, Remote Control : Home & Kitchen
EF511A Instructions for Use (IFU) (PDF) PuraFlame NING BO LI CHEN DIAN QI YOU XIAN GONG SI PuraFlame,24",Free,Standing,Electric,Fireplace,Log,Set,Insert,,750W/1500W,Heater,,6,Flame,Colors,with,5,Brightness,,Crackling,Sound,,Remote,Control,,
Symple Stuff, nbgb1017, F54528DEDEC542E0A3B818CBCC0C925F
File Info : application/pdf, 16 Pages, 4.04MB
DocumentDocumentElectric Fireplace Log Set Model: EF511A WARNING Read and understand this entire owner's manual, including all safety information, before plugging in or using this product. Failure to do so could result in fire, electric shock, or serious personal injury. CAUTION Keep this owner's manual for future reference. If you sell or give this product away, make sure this manual accompanies this product. DO NOT RETURN! Contact our customer service team for help first. Call: 909 206 6608 Email: customerservice@puraflame.com When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, injury to persons, and hyperthermia, including the following: Hyperthermia can result in death. Symptoms of hyperthermia include high body temperature, headache, nausea, vomiting, tiredness, dizziness, fainting, and rapid pulse. If you begin to experience symptoms related to hyperthermia, turn off the heater and seek medical attention. To avoid excessive room temperatures which can cause hyperthermia: DO NOT leave product running unattended in a confined space around infants, or individuals with reduced physical, sensory, or mental capabilities. EF511A 19.9" 13.8" 24" 9.8" 16.7" Note: Y Keep the packaging for future transportation and/or storage. Y If the unit needs to be returned, please make sure all the spare parts are packed inside and same as the original packaging. Check Spare Parts Y Open the packaging carefully and remove the cover. Y Check the spare part list below to verify all parts have been received. Y Carefully check if any damages that may have for the appliance or spare parts. EF511A Flat Washer (2pcs) DO NOT RETURN! Contact our customer service team for help first. Call: 909 206 6608 Email: customerservice@puraflame.com Please refer to section 5a. Manual Control Panel and 5b. Remote Control to test the appliance first before installation. Should any defects found, please contact service team for help. Call 909 206 6608 or email customerservice@puraflame.com. Locate the Appliance · For best results, install out of direct sunlight. · The appliance should be connected to an earthed electrical outlet and it must be easily accessible to allow disconnection. MINIMUM CLEARANCE TO COMBUSTIBLE Sides............................0 Floor............................0 Back.............................0 Top...............................0 Front............................36" Minimum 1. Fix the screen Install the screen on the firebox as shown in the first picture below and use 2pcs M5x12 screws and 2pcs flat washers to fix it on the firebox. 1. 2. 2. Plug in Make sure the plug is plugged very tightly and NO other appliances should be plugged onto the same circuit. 3. Insert into the Opening This unit does not require any special venting. It is recommended to install it in an opening with the following Minimum dimensions for Best flame effect to see: 22.8" 11.8" 25.2" Minimum Clearance to Combustibles Front: 36" Read and understand this entire owner's manual, including all safety information, before plugging in or using this product. Failure to do so could result in electric shock, fire, serious injury, or death. WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you suspect the unit is damaged, call a qualified service technician to inspect and replace any part of the electrical system if necessary. FLAME HEATER TEMPERATURE LED Display & Receiver STANDBY Note: When the heater is first turned on, a light odor may be present. This is normal and should not occur again unless the heater is not used for a long period of time. STANDBY: Turn on the appliance with the last used settings without any heat. Place the appliance into standby mode with all features turned off. FLAME: Press to cycle through 6 flame colors and off setting. HEATER: Press to cycle through the heat output options: Low-High-Off. Note: In order to prevent the product becoming too hot, there is a 10s delay when turning on the heater and a 10s delay when turning off the heater fan. TEMPERATURE: Press to cycle through 14 temperature settings. Note: If the heater will work or not depends on the temperature set and room temperature. Press TEMPERATURE button for 3s to change the unit between and . STANDBY BRIGHTNESS LOW HEAT TEMPERATURE FLAME CRACKLING HIGH HEAT TIMER BUTTON TITLE STANDBY FLAME FUNCTION TTuurrnnss on the appliance with the last used sseettings without any heat. Place the aapppliance into standby mode with all ffeeaattuurreessttuurrnneedd ooffff.. Press to cycle through 6 flame colors and off. BRIGHTNESS Press to cycle through 5 brightnesses and off. CRACKLING Press to cycle through 5 volumes and off. Press to turn on the heater on half heat LOW HEAT setting or turn off the heater. HIGH HEAT Press to turn on the heater on full heat setting or turn off the heater. Press to set the temperature from 1628(60-82) and 58(99). TEMPERATURE Note: Press for 3s to change the temperature unit between and . TIMER Press to cycle through 0.5H, 1H, 2H, 3H, 4H, 5H, 6H, 7H, 8H, 9H and off. IMPORTANT SAFETY INFORMATION FOR BATTERY 1. Two AAA battery are required for the remote control; 2. Use the thumb press and push the bar figure on the back cover down simultaneously, then take out the cover and remove the battery or insert the battery, after this place the cover back on the rear of the remote; 3. This AAA battery (non-recharged) is not to be recharged; 4. Different types of batteries or new and used batteries are not to be mixed; 5. Battery is to be inserted with the correct polarity; 6. Exhausted batteries are to be removed from the appliance and safely disposed of; 7. If the remote control is to be stored unused for a long period, the battery should be removed; 8. The supply terminals are not to be short-circuited. RESETTING THE THERMAL CUT OUT The appliance is fitted with an Electronic Safety Control (E.S.). This is a safety device, which switches off the fire if, for any reason, the appliance overheats, e.g. when covered. If the heater stops operating while the flame effect continues working normally, this indicates that the E.S. Control is in operation. The E.S. Control can only be re-set after the appliance has cooled down, and the appliance has been reset. Resetting of the E.S. Control proceeds is as follows: 1. Unplug the appliance and leave it off for approximately 10-15 minutes. 2. Remove any obstruction to the fan heater outlet or fan blades etc. Make sure that the power supply is disconnected with the plug socket outlet while doing this. 3. Plug and turn on the appliance and the E.S. Control will be reset. 4. Ensure that the appliance is functioning correctly. If the E.S. Control operates again, the appliance should be checked by a competent electrician. 6. CARE AND MATAINTENANCE ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in electric shock, fire, or personal injury. Cleaning NEVER immerse in water or spray with water. Doing so could result in electric shock, fire, or personal injury. Metal: Y Buff using a soft cloth, slightly dampened with a citrus oil-based product. Y DO NOT use brass polish or household cleaners as these products will damage the metal trim. Glass: Y Use a good quality glass cleaner and dry thoroughly with a paper towel or lint-free cloth. Y NEVER use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface. Plastic: Y Wipe gently with a slightly damp cloth and a mild solution of dish soap and warm water. Y NEVER use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface. Vents: Y Use a vacuum or duster to remove dust and dirt from the heater and vent areas. Y Clean the exterior of the fireplace with a slightly damp cloth or duster. Maintenance Risk of electric shock! DO NOT OPEN! No userserviceable parts inside! ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in electric shock, fire, or personal injury. Electrical and Moving Parts: Y The fan motors are lubricated at the factory and will not require lubrication. Y Electrical components are integrated in the fireplace and are not serviceable by the consumer. Storage: Y Store heater in a clean dry place when not in use. Replacement parts: Y Use only replacement parts supplied by the manufacturer. Use of any other parts, or modifying the fireplace in any way, will void all warranties. Y No internal parts are replaceable or serviceable. 7. LIMITED WARRANTY This warrants to the original purchaser that this product is free from defects in material and workmanship as of the date of purchase and that it will, under normal use and proper care, remain so for one year from the date of purchase. Missing or initially defective parts will be replaced free of charge during the period of this limited warranty. If parts are unavailable, comparable replacement of refund will be given. The original dated sales receipt is required for all warranty claims. This warranty does not cover damage which has occurred during transport from the point of purchase to the consumer's home. This warranty does not cover glass, light bulbs, batteries, transportation, labor, or other issues not associated with the manufacture of the product. This product is for residential use only. Any and all commercial use of this product voids all warranties, and frees the manufacturer from all liability. Read and understand all assembly and operating instructions, and all safety information and warnings, before use. The following will void this warranty: Damage caused from tampering with, modifying, or altering the fireplace insert in any manner; Damage due to incorrect assembly, improper care, misuse, or abuse; Damage from being used with the wrong power source; Water damage; Damage caused from this insert being used outdoors; Damage caused from this insert being used for excessive periods of time; Damage caused by the insert being used in a commercial application; Damage from use as a primary heat source; Other misuse or abuse not specifically listed herein. This product is not intended to be used as a primary heat source. It is for supplemental heating purposes only. Display Screen & Receiver Top Fuel bed LED board IR 8. SCHEMATIC DIAGRAM LED DISP Speaker Sensor Heat element 1 3 2 Thermostat 4 5 Heat motor M ~ Flame M ~ motor Button Panel FLAME FAN HEAT1 HEAT2 AC-N AC-L RC01-072 SIREN LED2 LED1 LED5 KEY RT IR LED6 LED4 CN1 Flame LED board Bottom Fuel bed LED board Log LED board AC120V/60Hz L E N Ningbo Richen Electrical Appliance Co., Ltd. Address: No.19, Yongdinghe Road, Xiapu, Beilun, Ningbo, P.R. China www.puraflame.com 3.EF.511.05.001 A0