Instructions for DALI models including: SRP-2305 30W DALI DT6 LED Dimmable Drive, SRP-2305, 30W DALI DT6 LED Dimmable Drive, LED Dimmable Drive, Dimmable Drive, Drive
1 giorno fa — 50/60Hz. THD. 12% (@ full load / 230VAC). ≤. 0.17A @ 230VAC. < 0.5mA /230VAC. Dips to set the operation current. 1 2 3 4. 250mA. 300mA. 350mA. 400mA. 450mA.
Important: Read All Instructions Prior to Installation. Operation. 1 DALI address can be assigned by DALI Master controller automatically, please refer to ...
30W DALI DT6 LED Dimmable DriverConstant Current LED Controlled Device 2 Important: Read All Instructions Prior to Installation Function introduction DALI signal input DA PUSH DIM L DA DA N DA - NC NC DALI DT6 Dimmable Driver 1 channel output Dips to set the operation current N L AC 200-240V input Product Data Selectable Current 250mA 300mA 350mA 400mA 450mA 500mA 550mA 600mA DC Voltage Range 8-55V 8-55V 8-55V 8-55V 8-55V 8-55V 8-54V 8-50V Output Selectable Current 650mA 700mA 750mA 800mA 850mA 900mA 950mA 1000mA DC Voltage Range 8-46V 8-42V 8-40V 8-37V 8-35V 8-33V 8-31V 8-30V Rated Power 30W max. Voltage Range 200-240V AC Input Frequency Range Power Factor (Typ.) Total Harmonic Distortion Efficiency (Typ.) 50/60Hz > 0.9 @ 230VAC THD 12% (@ full load / 230VAC) 83% @ 230VAC full load AC Current (Typ.) 0.17A @ 230VAC Inrush Current (Typ.) COLD START 8A max. at 230VAC Leakage Current Dimming Interface Control Dimming Range Dimming Method Dimming Curve Working Temp. Environment Max. Case Temp. Working Humidity Storage Temp. & Humidity < 0.5mA /230VAC DALI DT6 (DALI consumption<2mA)/ PUSH 0.1%-100% Amplitude dimming (PWM dimming under 1%) Logarithmic/ Linear -20 ~ +45 85 (Ta="45") 10% ~ 95% RH non-condensing -40 ~ +80, 10% ~ 95% RH Short Circuit Yes, auto recovery after fault removed Protection Over Voltage Yes, auto recovery after fault removed Over Temperature Yes, auto recovery after fault removed Safety Standards ENEC EN61347-1, EN61347-2-13 approved Withstand Voltage Safety&EMC EMC Emission I/P-O/P: 3.75KVAC EN55015, EN61000-3-2, EN61000-3-3 EMC Immunity EN61547, EN61000-4-2,3,4,5,6,8,11, surge immunity Line-Line 1KV Others MTBF Dimension 189400H, MIL-HDBK-217F @ 230VAC at full load and 25 ambient temperature 170*53.4*28mm (L*W*H) Dips to set the operation current 12 3 4 250mA 300mA 350mA 400mA 450mA 500mA 550mA 600mA 1234 650mA 700mA 750mA 800mA 850mA 900mA 950mA 1000mA 1234 · Dimmable DALI DT6 LED driver · In compliance with IEC 62386-101:2014, IEC 62386-102:2014, IEC 62386-207 Ed2 · Built-in DALI-2 interface, DALI DT6 device · Hybrid dimming method, smooth and deep dimming to 0.1%, flicker free · 1 channel constant current output, max. output power 30W · Output current 250mA-1000mA selectable by dip switches · Standby power consumption less than 0.5W · Class 2 power supply, full isolated plastic case · High power factor and efficiency · DALI DT6 device to control ON/OFFlight intensity output via a single DALI address · Compatible with universal DALI masters that support DT6 commands · IP20 rating, suitable for indoor LED lighting applications · 5 years warranty Safety & Warnings · DO NOT install with power applied to device. · DO NOT set operation current with power applied to device. · DO NOT expose the device to moisture. Operation 1. DALI Address Assigned by DALI Masters 1 DALI address can be assigned by DALI Master controller automatically, please refer to user manuals of compatible DALI Masters for specific operations. 2. Power On Level Power on level is a DALI parameter that defines the level of a control gear after power is restored. The factory default power on level for this driver is 100, which means the driver will be at 100% intensity when power is restored. 3.Push Dimmer Mode While connected with a AC PUSH, it means Push Dimmer Mode, and operations under Push Dimmer Mode are as follows: 1.1. Click the button to switch ON/OFF 1.2. Press and hold down the button to increase or decrease light intensity to desired level and release it, then repeat the operation to adjust light intensity to opposite direction. The dimming range is from 0.1% to 100%. 1.3. Memory function after power off or power failure enables the device to memorize the status before power off while power on again. 2.With PUSH Dimmer LN AC PUSH DA P US H D IM L DA DA N DA - NC NC DALI DT6 Dimmable Driver N L LED light Wiring Diagram 1.With DALI Bus DALI BUS DA DA DA PUS H DIM L DA DA N DA - NC NC DALI DT6 Dimmable Driver N L LN Product Dimension LED light 170 mmMicrosoft: Print To PDF