Universal Audio Dream '65 Reverb Amp Pedal

Product Overview

The Universal Audio Dream '65 Reverb Amp pedal emulates classic American tube amps, offering sought-after tones with authentic spring reverb and vibrato effects.

Controls

Front Panel Controls

• REVERB: Adjusts the amount of tube-driven spring reverb.
• VOLUME: Controls the input gain for the vibrato channel.
• SPEAKER: Cycles through available speaker cabinet emulations. When the associated LED is off, the amp remains active, but the speaker cabinet simulation is disabled.
• BASS: Adjusts the low frequencies.
• TREBLE: Adjusts the high frequencies.
• SPEED: Controls the rate of the vibrato effect.
• ON LED: Illuminates when the current knob settings are active.
• ON SWITCH: Toggles the pedal's effect on or off. An asterisk (*) indicates that more footswitch modes are available via the UAFX Control app.

Top Panel Controls

• ALT/AMP/STORE:
  • ALT: Activates vibrato controls on the Treble and Boost knobs.
  • AMP: Selects standard amplifier emulation modes.
  • STORE: Press and hold to save the current sound as a preset.
• OUTPUT: Sets the overall output volume of the pedal.
• AMP MOD: Selects amplifier modification modes:
  • LEAD: Emulates an '80s OD special modification.
  • STOCK: Provides a clean preamp boost.
  • D-TEX: Emulates an SRV modification with vibrato disabled.
• BOOST: Adjusts the boost amount. Set to OFF to bypass the boost circuit.
• INTENSITY: Controls the intensity of the vibrato effect. Set to OFF to bypass the vibrato circuit.
• PRESET LED: Illuminates when stored preset settings are active.
• PRESET SWITCH: Toggles between saved presets or bypasses the pedal.

Connections

• 9VDC POWER IN: Connect a 9VDC, 400 mA isolated power supply (sold separately).
• MONO IN: Connect a TS cable from your guitar or other gear for mono operation.
• STEREO IN: Connect a TS cable for stereo input, used in addition to the MONO IN.
• USB TYPE-C: Connect to a computer for firmware updates using the UAFX Control desktop app.
• MONO OUT: Connect a TS cable to an amplifier or other gear for mono output.
• PAIR: Press to activate Bluetooth discovery for the UAFX Control mobile app.
• STEREO OUT: Connect TS cables for stereo output, used in addition to the MONO OUT.

Power Supply Requirements

Requires an isolated 9VDC power supply with a center-negative polarity, a minimum current rating of 400 mA, and a 2.1x5.5 mm barrel connector (power supply sold separately).

Further Resources

For more features, bonus speaker cabinets, artist presets, and full manuals, visit uaudio.com/uafx/start.