Digital Camera User Manual
This manual provides instructions for operating your new digital camera, featuring 48.0 Megapixels, 16X Powerful Zoom, and 4K video capabilities.
Content
- Important Battery Safety Tips
- Introduction of Camera Parts
- Product Specifications
- How to Insert and Remove the Battery
- How to Charge the Camera
- How to Insert and Remove Micro SD Card
- How to Format a Memory Card
- Introduction to Camera System Settings
- Introduction of Still Image Mode
- Introduction to the Still Image Mode Menu Settings
- Introduction to Video Recording Mode
- Video Recording Mode Menu Settings Introduction
- How to Download Still Image/Video Files to Computer
- How to Use Camera as Webcam
Important Battery Safety Tips
For your better experience with this product, please pay attention to the following safety tips:
- If the battery pack is mishandled, it can burst, cause a fire, or even chemical burns. Observe the following cautions:
- Do not disassemble.
- Do not crush and do not expose the battery pack to any shock or force such as hammering, dropping, or stepping on it.
- Do not short circuit and do not allow metal objects to come into contact with the battery terminals.
- Do not expose to high temperature above 60°C (140°F), such as in direct sunlight or in a car parked in the sun.
- Do not incinerate or dispose of in fire.
- Do not handle damaged or leaking lithium-ion batteries.
- Be sure to charge the battery pack using a genuine battery charger or a device that can charge the battery pack.
- Keep the battery pack out of the reach of small children.
- Keep the battery pack dry.
- Replace only with the same or equivalent type recommended by the seller.
- Dispose of used battery packs promptly as described in the instructions.
Introduction of Camera Parts
The camera has the following parts:
| NO | Camera Parts | Introduction |
|---|---|---|
| 1 | Power Button | Power the camera on/off |
| 2 | Shutter Button | In still image mode: half press to focus, full press to take photo. In video mode: start/end recording. In playback mode: play/stop playing video file. |
| 3 | T Button | Electronic zoom/enlarge photo/increase video playback volume |
| 4 | W Button | Electronic zoom/zoom out photo/decrease video playback volume |
| 5 | Mode Button | Switching camera modes: still image mode, video recording mode, playback mode, camera system settings. |
| 6 | Up/Down/Left/Right Buttons | Up button: fill light (Automatic, Forced, Off) / menu selection. Down button: shortcut delete key/ menu selection. Left button: timer selfie button (in still image mode, press to set the timer photo countdown time 2s, 5s, or 10s) / menu selection. Right button: In still image mode, continuous shooting button (press this button to take 3 photos in a row)/ menu selection. |
| 7 | OK Button | Confirm selection button/pause or resume recording (video recording mode). |
| 8 | Menu Button | Enter or exit menu settings. |
| 9 | Hook | Attachable camera strap. |
| 10 | USB | USB Type-C. |
| 11 | Battery cover | Install battery and Micro SD card. |
| 12 | Tripod mount | Standard screw port. |
| 13 | LED fill light | LED fill light. |
| 14 | MIC Port | Recording voice. |
| 15 | Indicator light | The blue light indicates that the camera is working. The red indicator light indicates that the camera is charging. The red light goes out when fully charged. |
| 16 | Speaker | Play sound. |
Product Specifications
| Specification | Details |
|---|---|
| Video Resolution | 4K/2.7K/1080P FULL HD/720P HD/480PVGA |
| Image Resolution | 48M/44M/36M/24M/20M/16M/12M/10M/7M-Wide/5M/3M/2M-Wide |
| Memory Card | Support Micro SD card (4GB to 256GB Class10 is recommended) |
| File Format | JPG, AVI |
| Taking Photos | Single/Continuous shooting/2s timer/5s timer/10s timer |
| Electronic Zoom | 16X |
| USB Port | Type-C |
| Display | 2.8 inch Screen |
| Battery | Rechargeable Li-Ion Battery |
| Focal Length | f=7.36mm |
| Aperture | F/3.2 |
| Power Save | Auto power off in 1Min/3Mins/5Mins |
| Operating System Requirements | Windows XP, Windows Vista, Windows 7, Windows 8, Windows 10, Mac 10.2 |
How to Insert and Remove the Battery
- Open the battery cover.
- Insert the end with electrical contacts until it locks into place.
- Close the battery cover.
- To remove the battery, please push the battery lock.
How to Charge the Camera
- Please use the Type-C cable and charger included in the package to charge. The Type-C charging port is located on the camera.
- When the camera indicator light is red, it means the camera is charging.
- When the camera light goes out, it means the camera is fully charged.
- For the first time, please use it after fully charged.
How to Insert and Remove Micro SD Card
- Open the battery cover.
- As shown by the illustration, face the card's metal contacts side toward you and insert it until it locks in place.
- Close the battery cover.
- Please note: The camera supports 4-256GB Micro SD cards. Class10 is recommended; U3 level cards are not recommended.
- When the Micro SD card is used for the first time, please format it in the camera.
How to Format a Memory Card
- In the still image mode, press the "Mode" button 3 times to enter the system setting interface and select the "Format" option.
- Press "OK" to confirm formatting.
- Press the mode button again to exit the system settings page.
Introduction to Camera System Settings
- Press the mode button 3 times in the still image mode to enter the still image system settings.
- After the setting is completed, please press the Mode button to exit the system setting.
System Settings Options:
| NO | Option | Introduction |
|---|---|---|
| 1 | Language | Support multi-language. |
| 2 | Set Date | Set date and time. Please choose whether to display the date watermark on the photo. Date watermark is off by default. |
| 3 | Power Save | The camera will automatically shut down when there is no operation. Options: 1Min/3Min/5Min. Default is off. |
| 4 | Beep | Key sound. Default is off. |
| 5 | Frequency | 60Hz/50Hz. Default is 60Hz. |
| 6 | Format | You can choose whether to format the Micro SD card or not. |
| 7 | Default | This function is to reset your camera. |
Introduction of Still Image Mode
How to Take Still Image
- Please make sure the camera is in still image mode (the camera defaults to still image mode when turned on).
- Press the shutter button halfway down to focus. When the image is in focus, the focus frame in the screen will turn green.
- Press the shutter button fully down to shoot an image.
How to Play Back and Delete Still Images
- Press the mode button 2 times in the still image mode to enter the playback mode.
- Select an image by pressing the Left and Right keys.
- If you want to delete the photo, please press the Down button (this is the shortcut delete key).
- After viewing the photos, please press the mode button twice to exit the playback mode.
Introduction to Video Recording Mode
How to Shoot Video
- Please make sure the camera is in video recording mode. After turning on the camera, press the mode button once to enter video recording mode.
- Press the shutter button to start/end video recording.
- Press the OK button to pause/resume video recording.
How to Play Back and Delete Recorded Videos
- Please press the MODE button once to enter playback mode (when the camera is in video recording mode).
- Select a video by pressing the left and right keys.
- If you want to delete the video, please press the down button (this is the shortcut delete key).
- After viewing the video, please press the mode button twice to exit the playback mode.
How to Download Still Image/Video Files to Computer
- When the camera is turned on, use the Type-C cable (in the package) to connect the computer.
- After the connection is completed, a dialog box will pop up randomly on the camera screen.
- Please select MSDC, then you can download the files from the camera to your computer.
- After downloading, please remove the Type-C cable, and the camera will exit MSDC mode.
How to Use Camera as Webcam
- Please use the Type-C cable (in the package) to connect the computer with the camera when the camera is turned on.
- After the connection is completed, a dialog box will pop up randomly on the camera screen.
- Please select "PC Camera", then you can use the camera as a webcam on the computer.
- After using, please remove the Type-C cable, and the camera will exit webcam mode.
Model Number: DC402\DC402AF-4K
Manufacturing Date: 20231115
Compliance Marks: CE, ROHS, FC
