Installation Guide for n-FAB models including: HPD1980CC-TX, HPD1967QC-TX, HPD1980CC-TX Podium Hoop Step, Podium Hoop Step, Hoop Step
HARDWARE DESCRIPTION M8 1.25 HX FLANGED NUT 10MMX25MM CARRIAGE BOLT 10MM HEX FLANGED NUT QTY. 18 12 12 PARTS INCLUDED QTY DRIVER SIDE 1 PASSENGER SIDE 1 MOUNTING BRACKET 6 I-SHEET PART NUMBER: INST-00302 PART NUMBER: HPD1980CC-TX HPD1967QC-TX PRODUCT: PODIUM HOOP STEP APPLICATION: 2019-22 RAM 1500 CC QC Step 1: Locate the driver side step rail. HPD1980CC-TX DRIVER HPD1967QC-TX DRIVER 12302 Shiloh Church Rd. Houston TX 77066 Phone (281) 880-6322 - Fax (281) 880-6325 Step 2: Install the (x6) mounting brackets to each attachment point on the main tube using the supplied M10x25 carriage bolts, M10 hex nuts and leave loose for now. **** NOTE: The brackets will attach to the backside of the mounting flange with the threaded end of the carriage bolt facing towards the REAR of the step. *** REAR I-SHEET PART NUMBER: INST-00302 PART NUMBER: HPD1980CC-TX HPD1967QC-TX PRODUCT: PODIUM HOOP STEP APPLICATION: 2019-22 RAM 1500 CC QC Step 3: Remove any steps and old hardware from the vehicle. Step 4: On the inside rocker panel there will be three-attachment point consisting of three 8mm studs coming out from the panel. These studs may be covered in paint and will need to be cleaned before the installation. 12302 Shiloh Church Rd. Houston TX 77066 Phone (281) 880-6322 - Fax (281) 880-6325 Step 5: An additional person recommended for this step. Carefully install the Hoop step to the three factory attachment points using the provided M8 flanged hex nuts. Leave finger tight for now. Step 6: Next, adjust the Hoop step level with the body of the cab and tighten all hardware 30 ft. /lbs. Step 7: Tighten all brackets at the main tube. ( 20-25 ft./lbs. torque ). Step 8: Re-peat steps 2-7 for passenger side install.Microsoft Word for Microsoft 365