MT700 Cat M1 & NB-IoT Asset GPS Tracker User Manual V1.0

Preface

Thanks for purchasing Mictrack Asset GPS tracker MT700. This manual shows how to easily program and setup the tracker for the best results. Please read this manual carefully before using this product, so as to avoid delays or confusion with its operation. Please note that specifications and instructions are subject to change without notice to facilitate product improvement. Updates and changes will be integrated into the latest release. The manufacturer assumes no responsibility for any errors or omissions in outdated documents.

Visit: www.mictrack.com

FCC Caution

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

1. Quickly Reference

⚠ Warning

There is a Toggle Switch in internal. Please operate carefully.

• If you use Non-rechargeable batteries, Make sure Toggle Switch is to LEFT.
• If you use chargeable batteries, Make sure Toggle Switch is to RIGHT.
• REVERSE IS FORBIDDEN, Could Result in Fire or Explosion.

Toggle Switch Diagram Description: A warning symbol with an exclamation mark and a crossed-out battery indicates "REVERSE IS FORBIDDEN, Could Result in Fire or Explosion". Below this, two positions are shown: "LEFT" for "FOR NON-RECHARGEABLE BATTERIES" and "RIGHT" for "FOR RECHARGEABLE BATTERIES".

⚠ Non-rechargeable Batteries Recommendation

• Battery Type: Lithium Iron Disulfide (LiFeSO2) 3 x AA 1.5V cell batteries.
• Battery Brand: Energizer Ultimate L91 AA 1.5V.
• Battery holder: Buy from Manufacturer or your distributor.

NOTE:

• Lithium Thionyl Chloride (LiSOCl2) 3 x AA 3.6V cell batteries are unavailable now. If needed, custom hardware can be arranged; please contact Mictrack or your provider for more details.
• Non-rechargeable batteries need to be fully compatible with the original battery holder, or the device may cause damage, explosion, and fire.

⚠ Disclaimer

Before using this device, customers should fully understand their usage scenarios and installation environment. Mictrack will not be held responsible for any losses caused by using the devices in a wrong scenario or reporting rate. It is highly recommended that users should contact Mictrack before deployment. Mictrack is glad to provide suggestions.

2. Overview

The MT700 is an IP68 waterproof asset GPS tracker that uses Cat M1 & NB-IoT technology, providing super low power consumption for up to 15 years standby time powered by internal batteries. Its built-in powerful magnets allow for easy installation without wiring.

Users can track the unit in real-time via their mobile phone or PC anytime, anywhere. It has been widely used in fleet management, trailer tracking, container tracking, logistics, car rental, automobile finance, transportation, and other segments.

3. Features

• Cat M1 & NB-IoT & GSM Network
• GPS+Glonass+Galileo+Beidou System
• 15 Years Standby Time
• IP68 Dust & Water Resistance
• Dynamic Power Path Management
• Ultra Low Power Consumption (less than 1.5uA)
• Easy Installation
• Powerful Magnet Mount
• Bracket Kits (optional)
• Rugged Construction
• Real-timing Tracking
• Geo-fence Alarm
• Low Power Alarm
• Removal Alerts
• Smart Motion Detection
• Scheduled Timing Report
• GPS+WiFi Positioning (optional)
• Multiple Power Saving Mode Switching
• PC & Mobile App Tracking
• Programmable via Web/USB/SMS
• Open Protocol & Easy Integration with any third-party platform

4. Applications

• Trailer Tracking
• Container Tracking
• Logistics Tracking
• Vehicles Tracking
• Automobile Finance
• Fleet Management

5. Specifications

6. MT700 Interface

The MT700 device features the following interface elements:

• Waterproof Cover: Protects internal components.
• Power button: For turning the device on/off.
• Charge/SYS/GPS LED: Indicates charging status, system status, and GPS signal.
• Micro USB Port: For charging and configuration.
• SIM Card Slot: For inserting the SIM card.

7. In the box

7.1 Standard Accessories

• 1x MT700 Asset GPS Tracker
• 1x USB Charge Cable (for rechargeable version only)
• 1x Battery Holder (for Non-rechargeable version only)
• 1x Quick Start Guide

7.2 Optional Accessories

• 1x Car Charger
• 1x Power Adapter
• 1x USB Config Cable

8. Installation

8.1 SIM Card installation

• Obtain a Micro SIM Card (Cat M1 or NB-IoT) with at least 15MB of data per month.
• Open the Waterproof Cover using a screwdriver.
• Insert the SIM Card with a gentle push, aligning it with the SIM icon direction. Alternatively, watch the installation video at http://bit.ly/MT700-Install-Guide.
• Turn the Power button from OFF to ON.

8.2 LED Indications

8.2.1 Red indicator - Charge

8.2.2 Blue indicator - SYS

8.2.3 Green indicator - GPS

9. Setup and Configuration

For initial setup, connect the USB Config cable to configure the APN (contact your SIM card provider for the correct APN) and lock the network to CAT M1 or NB-IoT, depending on your SIM card support.

Further configurations can be made using the USB Config tool.

If your SIM card supports SMS, you can set up the unit using the following SMS commands (Sections 9.1-9.12).

Download the USB Config tool: https://bit.ly/MT700-Config-tool

Config tool user guide video: https://bit.ly/MT700-Config-Tool-User-Guide

9.1 Change the password

SMS Command format: 777+new password+old password

Example: 77712340000

Reply: SET USER PASSWORD OK.

Note: Default password is 0000.

9.2 Set APN (Access Point Name)

SMS Command format 1: #803#password#APN##

Example: #803#0000#nbiot##

SMS Command format 2: #803#password#APN#APN user name#APN password##

Example: #803#0000#CMNET#INTERNET#INTERNET##

Reply: SET GPRS APN OK

9.3 Set the IP and port

SMS Command format: #804#password#IP address(or domain)#port##

Example: #804#0000#e.trackits.com#7700##

Reply: SET SERVER IP AND PORT OK.

9.4 Working Mode

9.4.1 MODE 1 (Real Time Mode)

SMS Command format: MODE,1,password,T

Example: MODE,1,0000,60

Reply: SET TRACKER MODE:1 OK

Note: The device will report data every 60s. T is the interval time, ranging from 60 to 600 seconds. In this mode, GPS and TCP are always active.

9.4.2 MODE 2 (GPS Auto Mode)

SMS Command format: MODE,2,password,T, X, Y

Example: MODE,2,0000,10,1,1

Reply: SET TRACKER MODE:2 OK

Note:

• T is the report interval time, ranging from 10 to 60 minutes.
• X=0 means GPS wakes up only when the report interval time arrives; X=1 means GPS is always on.
• Y=0 means TCP wakes up only when the report interval time arrives; Y=1 means TCP is always connected.

9.4.3 MODE 3 (Deep Sleep Mode)

SMS Command format: MODE,3,password,T

Example: MODE,3,0000,1

Reply: SET TRACKER MODE:3 OK

Note: The device wakes up and reports data to the server every 1 hour, then goes to sleep again until the next hour. T is the interval in hours, ranging from 1 to 24 hours.

9.4.4 MODE 4 (Vibrate Mode)

SMS Command format: MODE,4,Password,T

Example: MODE,4,0000,60

Reply: SET TRACKER MODE:4 OK

Note: When the device detects continuous vibration for more than 1 minute, it wakes up and connects to the network. After connecting, it immediately reports data to the platform. If the device remains vibrating, MT700 reports to the server every 60 seconds. If there is no vibration for more than 7 minutes:

• During the 7 minutes, if no data is reported, it will go to sleep.
• During the 7 minutes, if data is reported and the last location is sent, it will wait for 3 minutes before going to sleep again. T is the interval in seconds, ranging from 60 to 600 seconds.

9.4.5 MODE 5 (WiFi Only Mode)

SMS Command format: MODE,5,password,T, X, Y

Example: MODE,5,0000,5,0,1

Reply: SET TRACKER MODE:5 OK

Note:

• T is the report interval time, ranging from 1 to 60 minutes.
• X is fixed to 0.
• Y=0 means TCP wakes up only when the report interval time arrives; Y=1 means TCP is always connected.

9.4.6 MODE 0 (AUTO Mode)

SMS Command format: MODE,0,T1,T2

Example: MODE,0,60,1

Reply: SET TRACKER MODE:0 OK

Note: This mode combines Mode 3 and Mode 4. T1 is the interval in seconds (60-600), and T2 is the interval in hours (1-24). When the device is still, it runs as Mode 3; when it detects vibration, it runs as Mode 4.

9.5 Setup Protocol

SMS Command format: #800#password#X##

Example: #800#0000#TCP##

Reply: SET SERVER TYPE OK

Note: X=TCP sets the protocol to TCP; X=UDP sets the protocol to UDP.

9.6 SET AGPS

Disable AGPS Location: 190+password

Example: 1900000

Reply: SET AGPS OFF

Enable Last Location: 191+password

Example: 1910000

Reply: SET AGPS ON.

9.7 Setup Last location report

Disable Last Location: 192+password

Example: 1920000

Reply: SET LAST VALID GPS OFF

Enable Last Location: 193+password

Example: 1930000

Reply: SET LAST VALID GPS ON.

9.8 Low Power alarm

When the unit's internal backup battery is low, it will upload location data to the server with the status "BLP".

9.9 Remove alarm

If the device is removed and the light sensor detects light, it will report location data to the server with the status "DEF".

9.10 Vibrate alarm

In Vibrate Mode (Mode 4), if the device is detected to vibrate for 1 minute, it will report location data to the server (using the customized interval time) with the status "TOWED".

9.11 Restart

SMS Command format: *RESTART#Password##

Example: *RESTART#0000##

The device will restart after receiving this command.

Reply: DEVICE WILL BE RESTART.

9.12 Reset

SMS Command format: *RESET#Password##

Example: *RESET#0000##

Reply: DEVICE WILL BE RESET.

10. App & PC Tracking platform

10.1 App install & Login

• Subscribe to the plan: https://shop.mictrack.com/product/gps-tracking-platform-service/. If you have already subscribed, please ignore this step.
• Search for "Yi tracker" in Google Play or iOS store to download the Mobile APP (not Yi tracker2). You can also scan the QR code below.

QR Code Description: A QR code is provided for downloading the "Yi tracker" mobile application.

• Choose "Login by Device No.".
• Input server: www.trackits.com
• Input your device's ID number and password (default is 123456) to log in.

Login Screen Description: The login screen shows fields for Username/Device No., Server, Password, and a Login button. The "Login by Device No." option is highlighted.

10.2 PC login

• Go to the web portal: www.trackits.com
• Choose "ID No.".
• Input your device's ID number and password (default is 123456) to log in.

11. Troubleshooting

Contact Information

For any questions, please do not hesitate to contact Mictrack:

Address: 706, United Building, Donghuan 1st Road, Longhua District, Shenzhen, China 518109

Tel: +86-755-28198746

Web: www.mictrack.com

Email: info@mictrack.com