Installation Guide for Ferm Living models including: Sill Junior Bed, Junior Bed, Bed
Ferm Living Sill Junior Bed - 2Modern
File Info : application/pdf, 7 Pages, 468.85KB
DocumentDocumentSILL JUNIOR BED ASSEMBLY MANUAL fermliving.com SILL JUNIOR BED ASSEMBLY MANUAL NEED FOR ASSEMBLING 1. 2 x Persons 1 x Hexkey 1 x Hexkey 12 x Drowels 4 x Connector 4 x Connector screws 24 x Lamella screws NEEDED TOOLS ASSEMBLY PROCESS x 12 Electrical drill Hammer 1 Screwdriver (Philips/Prozidriv Insert the drowels into the designated holes. Please note that you should not insert drowels in the middle hole. 2 2. x 4 Using a screwdriver, mount the connector screws on each end of the sideboards. 3. x 4 Insert the connector in the round holes of the head and footboard. Then, fix the head and footboard to the two sides by inserting the connector screws into the connector. Once in place, tighten everything well with the hex key. 3 4 4. x 24 As illustrated, mount the bed slats to the bed using the small bracket screws. 5 6 3 Fix the Sill Bed Guard to the chosen side of the bed by fastening the remaining two screws with the allen key, as illustrated in the drawing. SILL BED GUARD ASSEMBLY MANUAL fermliving.com BOX CONTENTS 1 x Guard board 1 x Support board 2 x Dowels 5 x Screws 1 x Allen key NEEDED TOOLS One person 1 x hammer ASSEMBLY PROCESS 1 As shown, insert the two dowels in the two holes in the support board. Please note that the holes for the dowels are slightly smaller. Use the hammer to make sure the dowels are well-positioned. 2 Attach the support board to the bed guard board using the allen key to fasten three screws, as illustrated in the drawing.