BEBONCOOL Game Controller for NS Quick Start Guide

First Time To Pair & Connect (Y and Home)

Pair & Connect: Press Y and Home Button Simultaneously.

1. Find Controllers Option → Click Change Grip/Order.
2. Press and hold the Y and HOME button simultaneously until the 4 LED lights flash in turn for 2 seconds. Release the button and wait for the connection to complete.

Note: Enter the Change Grip/Order page and complete the connection within 30 seconds. Staying on the page too long may prevent connection to the NS console.

Two players also supported: Press L + R on the controller.

Reconnect: Press Home Button. If the controller was previously paired, pressing the Home button will connect it rapidly. Ensure the NS console is turned on; this function does not support waking the console from standby mode.

Unable to connect? Follow these steps:

1. Turn off airplane mode.
2. On the NS console, go to System Setting → Controllers and Sensors → Disconnect Controllers, and delete this controller's information.
3. Follow the first-time connection method to re-pair the controller.

Screenshot (+&-)

Press '+' and '-' buttons simultaneously to capture the image of your NS console.

Adjust Vibration Intensity

There are two levels of vibration intensity: Weak and Strong.

1. Ensure the controller is connected to the NS console.
2. Press L, ZL, R, and ZR buttons simultaneously.
3. Release the buttons when you feel the vibration. Repeat to adjust vibration intensity.

Indicator Light

• Charging: 4 LED lights flash.
• Fully Charged: 4 LED lights are off.

Factory Motion Controls Calibration

1. Ensure the controller is powered off and placed on a flat surface.
2. Press the '-', 'B', and 'HOME' buttons simultaneously. Group A and Group B indicators will flash alternately.
3. Press the '+' button; all 4 LED indicators will flash alternately.
4. After approximately 15 seconds, all indicators will turn off, signifying the controller has finished calibrating.

Calibrate Control Sticks

If in-game characters drift automatically, calibrate the motion controls:

1. Navigate to System Setting → Controllers and Sensors → Calibrate Control Sticks on your NS console.
2. Follow the on-screen guide to complete the calibration.

Upgrade

BEBONCOOL provides sustainable upgrade services. If the controller cannot pair with the newest NS console version, please visit the official website for the latest firmware upgrade.

Official Website: www.beboncool.com/upgrade

FCC Compliance Details

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.