500B 500W Camera Edition
Instruction Manual
SAFETY NOTES
Important Safety Information:
- Fly only in safe areas away from other people. Do not operate R/C aircraft within the vicinity of crowds or people. R/C aircrafts are prone to accidents, failures, and radio interference. Pilots are responsible for their actions and any damage or injury occurred during the operation or as a result of R/C aircraft models. ⚠️
- This product is suitable for indoor and outdoor use. Please choose a place without obstacles and keep distance from crowds and pets. Do not fly near unsafe areas, for instance, a heat source, or power lines, to avoid damage by collision, entanglement, fire, electric shock, and loss of lives and property. ?
- This product is suitable for ages 14 and above. It may be difficult to learn to fly initially. Seek the guidance of an experienced pilot to learn faster. ??
DRONE DIAGRAM
Drone Components:
- Drone Body
- Blade Protector
- Blade
- Motor
REMOTE CONTROL DIAGRAM
Remote Control Components:
- Antenna
- Indicator
- Speed (Short Press: Speed change; Long Press: 360° right rotation; Double Long Press: Stop)
- Left Control Lever (Accelerator)
- Photo/Video
- One-key return/Headless fly (Left/Right)
- Power On/Off
- 3D Eversion (Short Press: 3D Eversion; Long Press: 360° right rotation; Double Long Press: Stop)
- Right Control Lever (Forward/Backward, Left/Right side fly)
- Fine adjustment of Forward/Backward
- Fine adjustment of Left/Right
REMOTE BATTERY INSTALLATION
Using the provided screwdriver, unscrew the battery cover and remove it. Install 4 AA batteries, ensuring they are installed correctly. Attach the cover back on and tighten the screw.
CHARGING YOUR DRONE
Use only the included charger. Plug one end of the charger into a USB port on a computer. Attach the other end of the cable to the rechargeable battery as shown in the diagram. For safety, the battery must be charged under adult supervision at all times.
- Charging time is 100 minutes.
- The controller will beep 3 times when the battery is at 75% and 2 times when at 50%.
- Ensure you charge the battery to 100% for each flight.
- Only use the provided charger.
SAFETY NOTES (Post-Charging)
- After the battery is fully charged, plug it into your drone.
- Place the drone on a flat surface and turn it on (switch located on the drone body).
- The drone's lights will be flashing. Switch on the remote controller.
- Push the throttle stick all the way to the bottom and then all the way to the top to pair.
- Your drone should now be paired, and the LED lights will be solid.
- You are ready to fly your drone!
FLIGHT ADJUSTMENTS
| Function | Description | Diagram Representation |
|---|---|---|
| Throttle | Slowly push the left throttle lever up to throttle up, or down to throttle down. | ?⬆️ / ?⬇️ |
| Turning | Using the left lever, you can turn the orientation of the drone's head. | ⬅️ / ➡️ |
| Forward/Backward | Using the right lever, push up to go forward, or down to go backward. | ⬆️ / ⬇️ |
| Left/Right | Using the right lever, push left to turn left, or right to turn right. | ⬅️ / ➡️ |
| Turning Trim | If the drone's head leans left/right, adjust the rudder trim. If the drone leans right, adjust rudder trim to the left. If it leans left, adjust rudder trim to the right. | ?️ ⬅️ / ➡️ |
| Forward/Back Trim | If the drone's head leans forward/backward, adjust the trim. If the drone leans forward, adjust backward trim. If it leans backward, adjust forward trim. | ?️ ⬆️ / ⬇️ |
| Sideways Trim | If the drone body leans left/right, adjust the left/right trim. If the drone leans right, adjust trim to the left. If it leans left, adjust trim to the right. | ?️ ⬅️ / ➡️ |
3D TUMBLING
To tumble your drone, push the 3D Tumble button on your controller. Once pushed, move the right control stick in any direction. The drone will flip in the direction you move the control stick. Ensure the drone is at least 6 feet off the ground to perform flips safely. ▶️
TROUBLESHOOTING
| PROBLEM | CAUSE | SOLUTION |
|---|---|---|
| The drone's lights are flashing but drone will not fly |
|
|
| The drone's blades are turning but drone will not fly |
|
|
| The drone shakes violently |
|
|
| Tail still off trim after fine tuning or inconsistent speed |
|
|
| Drone still wanders forward after trim adjustments during hover |
|
|
INSTALLING SD MEMORY CARD - DR500C/DR500W
If you purchased the DR500C/DR500W drone, follow these instructions for SD memory installation:
- Insert SD Card into the camera module as shown on the diagram. ?
- On your remote control, toggle video or photo to start the camera. (If you have the DR500W, you can activate camera and video settings through the application).
- To view images or video, carefully remove the SD card and insert it into a card reader.
FIRST PERSON VIEW - DR500W
STEP 1: Place the bracket on the remote control. ⬆️
STEP 2: Place the phone in the cradle clip. ?
DOWNLOAD AND INSTALLATION OF THE APP
Please download and install the “WIFI UFO” app from your app store, or scan the 2D codes (Figures 1 and 2).
Figure 1
Figure 2
CONNECT TO WIFI - DR500W
- Turn on your drone. You should see a blue light on the WiFi Module.
- On your phone, go to Settings > WiFi, find “Wifi UFO XXXX”, and connect.
- Open the WIFI UFO app.
- You are ready to fly your drone!
SPECIFICATIONS - DR500W
- Dimensions: 15" x 12.5" x 4"
- Weight: 0.20lb
- Body Design: 4 Rotors
- Gyroscope: 6-Axis
- Flight Range: 328ft
- Battery: 3.7V/600mAh Li-Po
- Charging Time: 100 min
- Flight Time: 7 min
- Giro 360°: Yes
- IOC (Frontal Location): Yes
- RTH (Return to Home): Yes
- FPV via Smartphone App
- Altitude Stability: Yes
- Camera: 0.3MP
- Remote Control: 2.4 GHz
- Batteries Required: 4 AA Batteries
CONTROL INTERFACE DESCRIPTION - DR500W
Control Interface Elements:
- 1. Return ↩️
- 2. Take Photo ?
- 3. Record Video ?
- 4. Photo & Video playback
- 5. Speed: Slow 30% ?, Quick 60% ?, High 100% ?
- 6. Height Limit
- 7. Gravity Sensor Mode
- 8. Show/Hide Control Interface
- 9. Camera Flip ?
- 10. Throttle Control
- 11/12. Left/Right Roll
- 13/14/15/16. Directional Control (left/right/forward/backward)
- 17/18. Forward/Backward Fine-Tune
- 19/20. Left/Right Roll Fine-Tune
- 21/22. Left/Right Fine-Tune
This device complies with FCC requirements and is subject to the condition that it does not cause harmful interference. For additional information, reference the full user's manual or visit www.ISWAGmobile.com. For support and warranty information, visit www.ISWAGmobile.com. Made in CHINA. ??
FC CE
iSWAG Mobile