Quick Reference Guide

NOTE: See your Use and Care Guide for more information. Not all settings and options are available on each cycle.

1. Touch Power to Turn On Washer

2. Before First Use: Run Wash Cycle Without Laundry

Before washing clothes for the first time, choose the Quick cycle and run it without clothes. This initial cycle serves to ensure the interior is clean before washing clothes.

3. Doing Laundry: Add Laundry Products, If Desired

Single-dose laundry packets, Oxi-type boosters, color-safe bleach, or scented crystals can be added to the drum prior to adding laundry.

4. Load Laundry

Place a load of sorted items loosely in the washer.

IMPORTANT: Push load fully into the washer. Make sure no items are resting on the rubber seal to avoid trapping them between the seal and the door window.

5. Add HE Detergent, If Desired

If you choose to use the Single Load Dispenser, add detergent to the appropriate compartment at this time.

6. Add Liquid Fabric Softener and Chlorine Bleach to Single Load Dispenser, If Desired

7. Select a Cycle

NOTE: Normal cycle is recommended for washing normally soiled cotton or linen clothes. This clothes washer's government energy certifications were based on the Regular + Normal cycle with Fast Spin, Medium Soil Level and all Wash Temperature selections offered in the cycle. It was tested as an Adaptive Automatic Water Fill Control System clothes washer. The settings as shipped are Regular + Normal cycle, Warm Wash Temp and Auto Water level.

• REGULAR
• DELICATES
• BULKY ITEMS
• WHITES
• COLORS
• TOWELS
• NORMAL
• WRINKLE CONTROL
• HEAVY DUTY
• SANITIZE with OXI
• COLD WASH
• QUICK

8. Adjust Cycle Modifiers, If Desired

Temp: Cold, Hot

Spin: Off, Fast

Soil: Light, Heavy

9. Select Any Additional Options

• Cycle Signal
• Extra Rinse
• Pre-Soak

10. Touch and Hold Start to Begin Wash Cycle

Touch and hold START for 3 seconds to start the wash cycle. To add 1-2 additional garments, pause the cycle by Touching START once to add garments; then touch and hold START again to continue the cycle. To cancel a cycle, touch and hold POWER.

Control Panel Overview

Power Button: Turns the washer on/off.

Cycle Status Display: Shows cycle progress (e.g., 0:20 for time remaining).

How to Wash Buttons: Selects wash cycles (e.g., REGULAR, DELICATES, NORMAL, QUICK).

Start Button: Initiates the selected wash cycle.

Cycle Modifiers: Adjust temperature (Temp), spin speed (Spin), and soil level (Soil).

Options Buttons: Select additional features like Cycle Signal, Extra Rinse, Pre-Soak.

Add Garment: Allows adding clothes mid-cycle.

Detergent Low: Indicator for detergent level.

Clean Washer: Button for running the self-cleaning cycle.

Drain & Spin: Button for draining or spinning.

Control Lock: ? [Hold 3 sec]

Maintenance

• Run Clean Washer cycle every 30 loads. The washer will also provide a reminder.
• Leave door open for ventilation when the machine is not in use.
• Check door seal between cycles. Clean out small items and/or debris if present.