Shoemaker Manufacturing
Phone: 1.866.940.0696 | Email: sm@shoemakermfg.com
Residential Submittal
Return Air Grille
MODEL: 1050 Series
Standard Features:
- Louvers run parallel to the 1st dimension specified
- 1/2" spacing dual angular louvers
- Stamped from cold roll steel
- Install with louvers in up or down position for best duct concealment
- Countersunk mounting holes with color matching Phillips Pozidriv screws
- Rust resistant pre-coat with durable powder finish
Options:
Finishes:
STANDARD COLORS
Soft White
Driftwood Tan
DESIGNER COLORS
Black
Bronze
Storm Gray
Cement Gray
Aluminum Paint
Coffee Tan
Warm White
Glossy White
Diagrams and Dimensions:
Diagram 1 (Top View of Grille): A rectangular return air grille with multiple parallel louvers. It shows four mounting screw holes, two on the top edge and two on the bottom edge, indicated by circles.
Textual description of a grille's top view.
Diagram 2 (Side View/Detail of Grille): A detailed view of the grille's side, showing the angled louvers and a mounting screw. It indicates a thickness of 1/4 inch.
Textual description of a grille's side detail.
Diagram 3 (Top/Cross-Sectional View with Dimensions): A diagram illustrating the grille's mounting to a duct. It shows dimensions: "NOMINAL + 1 5/8" for the overall width, "NOMINAL - 5/8" for the grille opening width, and "NOMINAL DUCT" for the duct width. The model number "1050" is also displayed.
Textual description of top mounting dimensions.
Diagram 4 (Side/Cross-Sectional View with Dimensions): Another diagram showing the grille's side profile and mounting. It indicates a thickness of 1/4 inch and a screw length of 1/2 inch. Dimensions for the opening are "NOMINAL + 1 5/8" and "NOMINAL - 7/16". The model number "1050" is also displayed.
Textual description of side mounting dimensions.
