Installation Guide
SpacePole Mini Kiosk Wall Mounted
CAUTION
Please ensure that you read and understand the content of the installation guide before you begin the installation process.
This product must be installed by a professional installer.
This product is designed to be mounted on a wall. Before installation, please verify that the supporting surface can bear the combined weight of the solution and hardware.
Do not overtighten the fixings.
It is the responsibility of the installer to use the appropriate fixings for the specific installation location. Please follow the fixing suppliers recommendations for installation.
This product is intended for indoor use only.
This solution is designed for certified hardware and accessories. Always follow the installation guide from the hardware manufacturer for correct installation.
Please do not power the hardware until the entire solution is fully assembled.
If these installation instructions are not followed precisely, it could lead to product failure and potential personal injury.
Ergonomic Solutions / SpacePole inc. cannot be held responsible for any product failure or personal injury if the installation instructions are not followed correctly.
Ergonomic Solutions / SpacePole inc. cannot be held responsible for any product failure or personal injury if any modifications have been made to the product by the customer.
Tool list
[Level tool], [Allen key]
Box content
- 1x (A) Wall bracket
- 1x (B) Kiosk module
- 1x (C) Front cover
Included hardware:
- 2 x M5x12 Hex headed screws
- 4 x M4 Thumb screws
- 4 x Ø4.2x5mm Spacers
Dimensions [mm]
Height: 525 mm
Width: 206 mm
Depth: 166 mm
Installation Steps
Step 1: Mount the screen to the VESA plate
Mount two of the included thumb screws to the top VESA holes on the screen and hook the screen onto the keyholes of the VESA plate. Then, attach the remaining two thumb screws to the bottom two holes on the screen and tighten them securely.
Note: For screens with short threaded inserts, use the included spacers.
Step 2: Adjust the screen height
To adjust the height of the screen, loosen the four screws slightly. Set the VESA mount to the desired height, and tighten the screws securely.
Step 3: Mount the wall bracket
Mount the wall bracket with M6 countersunk screws into the wall. It is the installer's responsibility to ensure that the correct fixings are used.
Step 4: Slide the wall module onto the wall bracket
Slide the wall module down over the wall bracket.
Step 5: Secure the module to the wall bracket
Remove the printer cover, and attach the module to the wall bracket with the two M5 x 12mm screws.
Step 6: Route the cables
Guide the cables from the screen down through the module and out through the cable hole at the bottom.
Step 7: Install the printer (optional)
Remove the protective paper from the Velcro. Guide the cables from the printer through the cable hole, position the printer as far forward as possible, and then press the printer down onto the self-adhesive Velcro.
If no printer is used, replace the front cover with Part C and skip this step.
Step 8: Reattach the printer cover
Reattach the printer cover.
Contact Information
Need help? Contact us:
