Acuity Brands Lighting
Instruction Manual for juno models including: P6300, P6300 Trac Adapter, Trac Adapter, Adapter
File Info : application/pdf, 2 Pages, 397.84KB
DocumentDocumentINSTALLATION INSTRUCTIONS For Juno Trac Adapter* WARNING Read all of these installation instructions before installing. SAVE THESE INSTRUCTIONS FIXTURE INSTALLATION Step 1 Find the latch and the polarity line. Align parts as shown and insert the adapter box into the track. (Fig. 1) Fig. 1 LATCH POLARITY LINE Fig. 2 Coming Soon Step 2 Pull down the latch while rotating the adapter box 90 degrees clockwise. (Fig. 2) Step 3 Final Position: Latch snaps into place between extrusion rails. Arrows on latch point toward the polarity line. (Fig. 3) Fig. 3 SECOND CIRCUIT POSITIONING Step 1 Raise the contact marked "P" (on switch side) by inserting a thin screwdriver blade under contact. Pull up into position as shown. (Fig. 4) (INSERT) (PULL) (ROTATE) Fig. 4 "P" CONTACT (LIFT) Step 2 Insert contact support (supplied with 2-circuit Trac section) by tilting and snapping into position under the "P" contact as shown. (Fig. 5) Fig. 5 Step 3 Ensure contact support is snapped and locked into position. (Fig. 6) Follow instructions for inserting into track. CONTACT SUPPORT Fig. 6 FINAL POSITION OF CONTACT SUPPORT *Juno Trac adapter size and style may vary. One Lithonia Way · Conyers, GA 30012 · 1-800-705-SERV (7378) · www.acuitybrands.com ©2020 Acuity Brands Lighting, Inc. P6300 Rev 10/2022 1 of 2 Coming Soon INSTALLATION INSTRUCTIONS For Juno Trac Adapter* TROUBLESHOOTING Problem Fixture doesn't turn on Cause Track not energized Adapter switch is in the "Off" position Fixture installed incorrectly Remedy Ensure track has power Ensure the power switch on the track fixture adapter is in the "On" position, see Fig. 9 Ensure fixture is installed correctly, with the arrows on the latch pointing towards the polarity line as shown in Fig. 3 Ensure contacts aren't bent from installing the fixture incorrectly, see Fig. 7 Fig. 7 "P" Contact adjusted incorrectly Ensure "P" contact isn't bent from adjusting incorrectly, see Fig. 8 Bent contact from adjusting the wrong contact, see Fig. 4, 5, & 6 for proper adjustment method Correct Single Circuit Position Used with T, TU, and R Series Track Incorrect Bent Contact Raised Contact Fig. 8 Correct Two Circuit Position Used with TU Series Track Incorrect Bent Contact Raised Contact Fig. 9 Move Switch To "On" Position Off On One Lithonia Way · Conyers, GA 30012 · 1-800-705-SERV (7378) · www.acuitybrands.com ©2020 Acuity Brands Lighting, Inc. P6300 Rev 10/2022 2 of 2