DB 1061AC Wireless Doorbell

Product Features

• 36 varied style melodies
• Polyphonic, pleasant sounding
• Adjustable volume in 3 stages
• Range in open terrain: approx. 100 m
• Operating frequency: 433.92 MHz
• Custom encoding with learning function
• Supports up to 8 push-buttons simultaneously
• Highly disturbance-protected from other bells
• Push button power supply: 1 x 3 V (CR2032) button battery (included)
• Doorbell power supply: 230 V~ / 50 Hz / 0.5 W

Installation

1. The push-button is supplied with a CR 2032 (3 V) button battery. Remove the insulation board if present.
2. Place the doorbell unit into a standard grounded power outlet.
3. Upon successful connection, the doorbell will emit a sound, indicating it is ready to be paired with the push-button.
4. Pair the two units together.

Pairing Instructions

After powering the doorbell, it will emit a sound, signaling it is ready to receive the push-button's signal.

1. Within 2 minutes, press the push-button once to create a new operating code. The doorbell sounding confirms the new code has been registered.
2. To pair additional push-buttons, unplug the doorbell, then plug it back in. The doorbell is now ready to register a new code.
3. Within 2 minutes, press the second push-button (sold separately) and the doorbell will learn its operating code.
4. By repeating this process, up to 8 push-buttons can be paired to a single doorbell.

After a power outage, the doorbell will start with its learning function. This can be bypassed by pressing an already paired button.

Melody Selection

A single press of the push-button plays the melody once. Holding the button down will not repeat the melody.

To select a desired melody, press the button located on the side of the doorbell, above the volume slider. This selected melody will play with each ring.

Removing the button battery will reset the melody to the factory default setting, but the push-button does not need to be re-paired.

Cleaning

For optimal operation, clean the appliance periodically, at least once a month, depending on the level of contamination.

• Before cleaning, remove the doorbell from the power outlet.
• Use a soft, dry cloth. Do not use aggressive cleaning agents or liquids.

When reconnected to power, the doorbell automatically enters learning mode. This can be bypassed by pressing an already paired button.

Warnings and Safety Information

General Warnings

• Before use, ensure the product is not damaged. Using a damaged product is prohibited and life-threatening.
• Random ringing may be caused by nearby bells or electrical equipment. In such cases, delete codes by removing batteries for 10 seconds and re-pair the units.
• After a power outage, pairing and melody selection must be repeated. If pairing fails, briefly remove the doorbell from the mains.
• Never attempt to disassemble the doorbell.
• Electrostatic discharge may cause memory loss. Re-pair the units if this occurs.
• If the range decreases, replace the batteries. Battery capacity decreases in cold conditions. Do not mix battery types or used/new batteries. Do not use rechargeable batteries.
• Walls, metal objects, and nearby radio-frequency equipment can reduce the range. Do not place the push-button on metal or UPVC door frames.
• The doorbell is designed for indoor use. Protect it from dust, humidity, liquids, frost, shock, and direct heat or sunlight. Do not place it in a kitchen or bathroom. The outdoor unit must be installed in a location protected from direct rain and sunshine.

Battery Safety Warnings

• WARNING! RISK OF EXPLOSION IN CASE OF INCORRECT BATTERY REPLACEMENT! Use only the same or an equivalent replacement type.
• Do not expose batteries to direct thermal radiation or sunlight. Do not burn batteries.
• If battery liquid leaks, wear protective gloves and clean the battery holder with a dry cloth.
• KEEP BATTERIES OUT OF REACH OF CHILDREN! It is forbidden to open, burn, short-circuit, or charge batteries! RISK OF EXPLOSION!
• This product contains a button cell battery. DO NOT SWALLOW THE BATTERY, RISK OF CHEMICAL BURN! If swallowed, it can cause severe internal burns within 2 hours and may lead to death.
• Keep new and used batteries out of reach of children.
• If the battery compartment cover does not close securely, discontinue use and keep the product away from children.
• If you suspect a battery has been swallowed or entered any body part, seek immediate medical attention.

Disposal Information

Waste equipment must be collected and disposed of separately from household waste, as it may contain components hazardous to the environment or health.

• Used or waste equipment can be returned free of charge at the point of sale or to any distributor selling equipment of identical nature and function.
• Dispose of the product at a facility specializing in electronic waste collection.
• This protects the environment and the health of others and yourself. Contact your local waste management organization for questions.

Disposing of Batteries and Accumulators: Batteries and accumulators must not be handled with regular household waste. It is the user's legal obligation to dispose of used batteries/accumulators at a nearby collection center or retail shop to ensure environmentally friendly neutralization.

IP Rating

Meaning of IP44: Protected from the entry of solid objects larger than 1 mm. Protected from splashing water (from all directions).