Heinner – large appliances, small appliances, housekeeping, DIYHeinner – large appliances, small appliances, housekeeping, DIY
NOD - Network One DistributionNOD - Network One Distribution
User Manual for HEINNER models including: HTCH-490GBK, HTCH-490IX, HTCH-490GBK Telescopic Cooker Hood, HTCH-490GBK, Telescopic Cooker Hood, Cooker Hood, Hood
prieš 7 dienas — Before using the appliance, please carefully read this instruction manual and keep it ... carefully before using even if you are familiar with the product.
File Info : application/pdf, 13 Pages, 3.03MB
DocumentDocumentwww.heinner.ro TELESCOPIC COOKER HOOD Model: HTCH-490GBK/HTCH-490IX · Telescopic cooker hood · Suction power: 413.5 m³/h · Color: black/inox www.heinner.com 105W, 50Hz, 220-240V Thank you for purchasing this product! I. INTRODUCTION Before using the appliance, please carefully read this instruction manual and keep it for future reference. This instruction manual is designed to provide you with all required instructions related to the installation, use and maintenance of the appliance. In order to operate the unit correctly and safety, please read this instruction manual carefully before installation and usage. III. SAFETY PRECAUTIONS II. CONTENT OF YOUR PACKAGE Telescopic cooker hood User manual Warranty card 1 www.heinner.com 105W, 50Hz, 220-240V This manual explains the proper installation and use of your cooker hood, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference. Never to do: · Do not try to use the cooker hood without the grease filters or if the filters are excessively greasy! · Do not install above a cooker with a high-level grill. · Do not leave frying pans unattended during use because overheated fats or oils might catch fire. · Never leave naked flames under the cooker hood. · If the cooker hood is damaged, do not attempt to use. · Do not flambé under the cooker hood. · Caution: Accessible parts may become hot when used with cooking appliances. · The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the cooker hood. (When the cooker hood is located above a gas appliance, this distance shall be at least 65 cm). · The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels. Range hoods and other cooking fume extractors may adversely affect the safe operation of appliances burning gas or other fuels (including those in other rooms) due to back flow of combustion gases. These gases can potentially result in carbon monoxide poisoning. After installation of a range hood or other cooking fume extractor, the operation of open flued gas appliances should be tested by a competent person to ensure that back flow of combustion gases does not occur. Always to do: · Important! Always switch off the electricity supply at the mains during installation and maintenance such as light bulb replacement. · The cooker hood must be installed in accordance with the installation instructions and all measurements followed. · All installation work must be carried out by a competent person or qualified electrician. · Please dispose of the packing material carefully. Children are vulnerable to it. · Pay attention to the sharp edges inside the cooker hood especially during installation and cleaning. · Make sure the ducting has no bends sharper than 90 degrees as this will reduce the efficiency of the cooker hood. · Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. · 2 www.heinner.com 105W, 50Hz, 220-240V · Warning: Before obtaining access to terminals, all supply circuits must be disconnected. · Always put lids on pots and pans when cooking on a gas cooker. · When in extraction mode, air in the room is being removed by the cooker hood. Please make sure that proper ventilation measures are being observed. The cooker hood removes odours from room but not steam. · There shall be adequate ventilation of the room when the cooker hood is used at the same time as appliances burning gas or other fuels. · Cooker hood is for domestic use only. · If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. · This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. · Caution: The appliance and its accessible parts can become hot during operation. Be careful to avoid touching the heating elements. Children younger than 8 years old should stay away unless they are under permanent supervision. · There is a fire risk if cleaning is not carried out in accordance with the instructions. · Regulations concerning the discharge of air have to be fulfilled. · Clean your appliance periodically by following the method given in the chapter Maintenance. · For safety reason, please use only the same size of fixing or mounting screw which are recommended in this instruction manual. · Regarding the details about the method and frequency of cleaning, please refer to maintenance and cleaning section in the instruction manual. · Cleaning and user maintenance shall not be made by children without supervision. · When the cooker hood and appliances supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). · Warning: Danger of fire. Do not store items on the cooking surfaces. · A steam cleaner is not to be used. · Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. 3 www.heinner.com IV. INSTALATION 105W, 50Hz, 220-240V Mounting of the V-Flap If the cooker hood does not have an assembled V-flap 1, you should mount the half-parts to its body. The images only show an example of how to mount the V-flap, because the outlet may vary according to different models and configurations. To mount the V-flap 1 you should: · Mount two half-parts 2 into the body 6. · The pin 3 should be top oriented. · The axis 4 should be inserted into the holes 5 on the body. · Repeat all the operations for the 2nd half-part. A. Wall mounting If you have an outlet to the outside, your cooker hood can be connected as below picture by means of an extraction duct (enamel, aluminum, flexible pipe or non-flammable material with an interior diameter of 150mm). 1. Before installation, turn the unit off and unplug it from the outlet. 2. The cooker hoods should be placed at a distance of 65-75cm from the cooking surface for best effect. 3. To install onto the wall, drill 4 holes of Ø 8mm on a suitable place according with the centre distance of hole in the back of the cooker hood. 4 www.heinner.com 105W, 50Hz, 220-240V 4. Insert the nut into the holes. 5. Insert the screws into the nuts and tight. 6. Hang the cooker hood onto the fixed screws. 7. Attach the one-way valve onto the cooker hood. Lay the expansion pipe (not included) on the valve. Lift up the expansion pipe till it out of the wall through the hole on the wall. B. Cabinet Mounting 1. Attach the one-way valve onto the cooker hood. 2. Drill 6 holes of Ø 4mm at the bottom of the hanging cupboard. 3. Put the one-way valve on the air outlet of cooker hood, then install the cooker hood on the bottom of the cupboard, tighten the cooker hood with enclosed M4 screws and flat washers. 5 www.heinner.com 105W, 50Hz, 220-240V 4. Install the adjusted board on the bottom of the hood to keep out the gap between hood back and cupboard. 5. Lay the expansion pipe (not included) on the valve. Lift up the expansion pipe till it out of the wall through the hole on the wall. Warning: For safety reason, please use only the same size of fixing or mounting screws which are recommended in this instruction manual. Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. 6 www.heinner.com V. OPERATION 105W, 50Hz, 220-240V There are 3 speeds for the motor and on/off switch for the lamp. 1. Lamp Turn on/off light "O" to switch off light. "I" to switch on light. Power Slide out drawer, power on; slide in drawer, power off. 2. Speed select speed to suit cooking conditions "O" to switch off motor. Low (I) light frying/boiling Medium (II) frying/wok cooking/heavy boiling High (III) grilling, intensive frying and wok cooking Power Slide out drawer, power on; slide in drawer, power off. 7 www.heinner.com VI. TROUBLESHOOTING 105W, 50Hz, 220-240V Fault Possible Cause Solution Light on, but motor does not work Fan switch turned off Fan switch failed Motor failed Select a fan switch position. Contact service center. Contact service center. Light does not work, motor does not work House fuses blown Mains power cable is loose or disconnected Reset/Replace fuses. Refit mains power cable to power outlet. Switch power outlet on. Oil leakage Lights not working One way valve and the outlet are not tightly sealed Leakage from the connection of chimney and cover Broken or faulty bulbs Take down the one-way valve and seal with sealant. Take chimney down and seal. Replace bulbs as per this instruction. Insufficient suction The distance between the cooker hood and the gas top is too far Refit the cooker hood to the correct distance. The Cooker hood inclines The fixing screw is not tight enough Tighten the hanging screw and make it horizontal. Note: Any electrical repairs to this appliance must conform to your local, state and federal laws. Please contact the service centre if in any doubt before undertaking any of the above. Always disconnect the unit from the power source when opening the unit. 8 www.heinner.com VII. CLEANING AND MAINTENANCE 105W, 50Hz, 220-240V Caution: · Before maintenance or cleaning is carried out, the cooker hood should be disconnected from the mains power supply. Ensure that the cooker hood is switched off at the wall socket and the plug removed. · External surfaces are susceptible to scratches and abrasions, so follow the cleaning instructions to ensure the best possible result is achieved without damage. GENERAL Cleaning and maintenance should be carried out with the appliance cold especially when cleaning. Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces. STAINLESS STEEL The stainless steel must be cleaned regularly (e.g. weekly) to ensure a long life expectancy. Dry with a clean soft cloth. A specialized stainless steel cleaning fluid may be used. Note: Ensure that wiping is done along with the grain of the stainless steel to prevent any unsightly crisscross scratching patterns from appearing. CONTROL PANEL SURFACE The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is clean and well wrung before cleaning. Use a dry soft cloth to remove any excess moisture left after cleaning. Important: Using neutral detergents and avoid using harsh cleaning chemicals, strong household detergents or products containing abrasives, as this will affect the appearance of the appliance and potentially remove any printing of artwork on the control panel and will void manufactures warrantee. GREASE MESH FILTERS The mesh filters can be cleaned by hand. Soak them for about 3 minute in water with a mild detergent and then brush it gently with a soft brush. Do not apply too much pressure so as to avoid any damage to it. (Leave to dry naturally out of direct sun light) Filters should be washed separately to crockery and kitchen utensils. It is advisable not to use rinse aid. 9 www.heinner.com 105W, 50Hz, 220-240V INSTALLING GREASE MESH FILTERS To install filters for the following four steps: · Angle the filter into the slots at the back of the hood. · Push the button on the handle of the filter. · Release the handle once the filter fits into a resting position. · Repeat to install all filters. CARBON FILTER (not included in the package) Activated carbon filter can be used to trap odors. Normally the activated carbon filter should be changed every 3 to 6 months according to your cooking habits. The installation procedure of activated carbon filter is as below: · Put the pin of the carbon filter into the rectangular hole of the fan (as per the arrow A shown below) · Push the other side of the carbon filter toward the fan to make it flat (as per the arrow B shown) and then press filter into fan. · If you want to remove the filter, press fastener of filter and remove it by turning anticlockwise. Note: · Make sure the filter is securely locked. Otherwise, it would loosen and cause danger. · When activated carbon filter attached, the suction power will be lowered. BULB REPLACEMENT · The bulb must be replaced by the authorized service or similarly qualified persons. · Always switch off the electricity supply before carrying out any operations on the appliance. When handling bulb, make sure it has completely cooled down before any direct contact with hands. · When handling bulbs hold with a cloth or gloves to ensure perspiration does not come in contact with the bulb as this can reduce the life of the bulb. Note: · · Before changing the lights, make sure that the appliance is turned off and unplugged. Protect against danger when changing lights, such as wearing gloves. 10 www.heinner.com 105W, 50Hz, 220-240V Changing the lights: · Remove the grease filter. · Find out the junction box, unscrew the screws on the junction box cover, then take down the junction box cover. (If there is wire pressing plate which pressed the light wire, the wire pressing plate needs to be dismantled first). See Pic 1. · Find out the terminal of the light connecting wire and pull it out. See Pic 2. · Use a tool or the hand to press the spring splinter of both sides of LED light to the inside, until the light is pressed out, then slightly pull the light connecting wire out, see Pic 3. · Apply the reverse procedure to reinstall the light. - LED modules round lamp - Max wattage: 2x1.5W - Voltage range: AC 220-240V - Dimensions: 11 www.heinner.com 105W, 50Hz, 220-240V VIII. TECHNICAL FICHE Suction power: Motor Color: 413.5 m³/h 1 x 105W Black/Inox Environment friendly disposal You can help protect the environment! Please remember to respect the local regulations: hand in the non-working electrical equipment's to an appropriate waste disposal center. HEINNER is a registered trademark of Network One Distribution SRL. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from NETWORK ONE DISTRIBUTION. Copyright © 2013 Network One Distribution. All rights reserved. www.heinner.com, http://www.nod.ro http://www.heinner.com, http://www.nod.ro This product is in conformity with norms and standards of European Community Importer: Network One Distribution Str. Marcel Iancu, nr 3-5, Bucuresti, Romania Tel: +40 21 211 18 56, www.heinner.com , www.nod.ro 12