XBOX ONE 2.4G Wireless Controller Function Description

Product Application

This product is a 2.4 GHz wireless controller for the XBOX ONE host. It operates on a 2.4 GHz frequency, offering wireless remote control for racing, fighting, athletics, and other games, enhancing the XBOX ONE console gaming experience.

Product Features

• 2.4 GHz wireless technology with an effective range of approximately 30 feet.
• 'Menu' and 'View' buttons for quick and easy navigation.
• Compatible with XBOX ONE, PC (D-INPUT, pc360x-input for WIN10 system), PS3 host, and Android systems (automatic identification).
• Enhanced joystick sensitivity and arrow keys for improved accuracy.
• Vibration motor with new design provides accurate finger touch feedback for a lifelike weapon, impact, and vibration experience.
• Built-in double motors and a 256-precision 3D rocker.
• Sensitive key response for easy control.

Controller Layout:

[Back Button] [Start Button] [X Button] [Y Button] [B Button]

The Wireless Handle Works Like This:

1. Connecting to XBOX ONE Host: Plug the receiver into the host's USB port. The receiver's light will flash. Press the handle's HOME key; the handle's light will flash. When the handle's light and the receiver's light are continuously on, the connection is successful and the controller can be used normally.
2. Connecting to Computer: Follow the same steps as connecting to the XBOX ONE host. When the controller light and receiver light are on continuously, the connection is successful in XBOX ONE mode. Long press the HOME button for 5 seconds to switch to Xinpu and Dinpu mode.
3. Charging Operation: When the handle's voltage is low, the 4 lights under the HOME button will flash to indicate charging is needed. Connect the USB charging cable to a +DC5.0V voltage source. The 4 lights under the HOME button will flash slowly while charging and will remain lit when fully charged.

FCC Compliance Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements and can be used in portable exposure conditions without restriction.