Instruction Manual for Shenzhen Xinmaigao Electronic Technology models including: XMGS17, 2A3L6-XMGS17, 2A3L6XMGS17, XMG- S17, Wireless Charging Mouse
Shenzhen Xinmaigao Electronic Technology Co., Ltd. XMGS17 wireless mouse 2A3L6-XMGS17 2A3L6XMGS17 xmgs17
PRODUCT INSTRYCTIONS XMG- S17 Wireless charging mouse 1. FEATURES XMG-S17 is a 2.4G charging with USB interface (Type-C port). This mouse has a super pointer Positioning performance and higher resolution; ensure stability/low power consumption/ anti-interference. It is convenient for users to work and other entertainment. 3 1 2 4 6 5 7 10 11 12 8 9 2. THE MOUSE FUNCTION: (1) 1Left button 2Right button 3Middle button 4Forward 5Backward 6DPI+ 7DPI- 8Power switch 9Receiver storage compartment 10Type-C charging port 11DPI indicatoralow pressure indicator 12Charge indication (2) When switching DPI, there is a green light at the bottom, flashing once for the first gear, and flashing five times for the fifth gear 3. INSTALLATION INSTRUCTIONS: (1) Support operating system: XP, Win7, Win8, Win10, etc. (2) Hardware connection: insert the product USB plug into the USB 1.1 or above port (When the product is used for the first time, the lower right corner of the computer will pop up an automatic hardware installation prompt) (3) Move the mouse and the pointer on the computer screen can move accordingly, and the mouse can be used normally. (4) Power supply mode: 3.7v polymer lithium battery / charging 500mA (5) Charging voltage and interface: 5V direct current (Type-C port) (6) Charging current: about dc 300mA (7) Code matching method: long press the middle button and the right button for 3 seconds, the green light flashes, and then plug in the receiver (the code has been aligned before leaving the factory) 8Weight: Receiver 86g (receiver weights 1.6g) manually weighed 9Working current: ordinary: 5mA (10) DPI adjustment :(Counts Per Inch) 600/1000/1600/2400/3200 (11) Size: (length * width * height) with hand rest 108*69*41mm This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.Adobe PDF library 15.00 Adobe Illustrator(R) 17.0