TKH Security - Home
User Guide for TKH Security models including: PD1024 Network PTZ Dome Camera, PD1024, Network PTZ Dome Camera, PTZ Dome Camera, Dome Camera, Camera
» PD1024
PD1024 – Catalog | TKH Security
File Info : application/pdf, 2 Pages, 576.59KB
DocumentDocumentPD1024 4MP Network PTZ Dome Camera Quick Start Guide Unpack Camera Unit Screws(4x) & Plastic Screw Anchors (4x) Combi-connector 3pin(2x), 4-pin(1x) Security Torx Quick Start Guide, Boring Template Anti-drop cable Power adapter Subject to modification. Actual product and accessories may differ in appearance. SD Card & Default Decorative Rim Remove the silicon plug and unscrew 4x to remove cover Silicone Plug 5 Memory Card Slot Memory Card Cover Remove memory card cover and insert MicroSD/SDHC/SDXC up to 256GB © TKH Security B.V. 2024 | Version 1 (20240529) | PD1024-QS-EN Find additional manuals, the datasheet, the EU Declaration of Conformity, and the latest firmware for this product at: tkhsecurity.com Installation Notices Caution installation shall be performed by qualified personnel only. Installation shall be in accordance with local procedures. The camera contains batteries. Battery replacement shall not be applied in view of the risk of explosion. Dispose of used batteries according to the instructions. For "PoE" input connection, use only with UL listed I.T.E. with "PoE" output. Description for the "PoE" is intended to be connected to not exposed (outside plant) networks or equivalent statement in installation instructions. Seal the connectors on the cable tail appropriately to protect them from water ingress. Connectors 1 Power (DC12V) Ground 2 Alarm in Alarm Out 3 Audio I/O RJ-45 Port 4 802.3at PoE+ Figure 1 Camera Connectors Default Button Press the button with a proper tool for at least 20 seconds to restore the system. Figure 3 Position of hardware reset button Camera Cabling No. Connector 1 Alarm I/O Definition Alarm I/O connection 2 Audio I/O Line In and Line Out connection 3 RJ-45 Port For network and PoE+ connections. Contact TKH Security for a compatible PoE+ injector. 4 Power(DC 12V) 5 Reset Button Power Connection To restore camera to factory defaults, power up with Reset button pressed for at least 20s. Insert the SD card into the card slot to store 6 Micro SD Card Slot videos and snapshots. Do not remove the SD card when the camera is powered on. Table 1 Connector definition Accessing the Camera - DHCP DHCP Accessing the camera Fixed IP 30s IP = 10.x.y.z Network Switch IP = 10.x.y.z IP = 192.168.1.x (try 192.168.1.64 first) Network Switch IP = 192.168.1.x Auto detect with SDM2 1 SDM2-vx.xx-setup.zip Tkhsecurity.com Enter to the camera product page. 2 3 DHCP 1st time camera login Set a strong password DHCP 1st time camera login Look for SDM2 Browser-based Viewer x6W@oM0a!9#F qwer1234 x6W@oM0a!9#F © TKH Security B.V. 2024 | Version 1 (20240529) | PD1024-QS-EN It is not recommended to continuously (24/7) record with the micro-SD card, as the camera may not support long-term continuous data read/write. Contact the manufacturer of the micro-SD card for information regarding the reliability and the life expectancy.