MERCUSYS Desktop Switch Installation Guide

Connection Diagram

Connect the hardware according to the connection diagram. The diagram illustrates a typical setup where the switch is connected to a router (via WAN Port and Internet) and a PC (via LAN Port) using Ethernet cables. A power adapter is shown connected to the switch.

Diagram Elements:

• Switch: The central networking device.
• Router: Connected via WAN Port and Internet.
• PC: Connected via LAN Port.
• Power Adapter: Supplies power to the switch.

LED Explanation

Power LED

On: The power is on.

Off: The power is off.

Ethernet Ports

On: The port is connected.

Blinking: The port is sending or receiving data.

Off: The port is not connected.

FAQ (Frequently Asked Questions)

Q1. What should I do if the Power LED is off?

A1: Make sure the power adapter is connected to the switch with the power source properly.

A2: Make sure the voltage of the power supply meets the requirements of the input voltage of the switch.

A3: Make sure the power source is ON.

Q2. What should I do if the Ethernet LED is off when a device is connected to the corresponding port?

A1: Make sure that the cable connectors are firmly plugged into the switch and the device.

A2: Make sure the connected device is turned on and working properly.

A3: The cable must be less than 100 meters long (328 feet).

EU Declaration of Conformity

MERCUSYS hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC, and 2011/65/EU. The original EU declaration of conformity may be found at http://www.mercusys.com/en/ce.

Safety Information

• Keep the device away from water, fire, humidity, or hot environments.
• Do not attempt to disassemble, repair, or modify the device.
• Do not use a damaged charger or USB cable to charge the device.
• Do not use any other chargers than those recommended.
• The adapter shall be installed near the equipment and shall be easily accessible.
• Please read and follow the above safety information when operating the device. MERCUSYS cannot guarantee that no accidents or damage will occur due to improper use of the device. Please use this product with care and operate at your own risk.

Copyright & Trademarks

Specifications are subject to change without notice. MERCUSYS is a registered trademark of MERCUSYS TECHNOLOGIES CO., LIMITED. Other brands and product names are trademarks or registered trademarks of their respective holders.

No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from MERCUSYS TECHNOLOGIES CO., LIMITED. Copyright © 2018 MERCUSYS TECHNOLOGIES CO., LIMITED. All rights reserved.

Visit http://www.mercusys.com for more information.

CE Mark Warning

This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Use only power supplies provided by the manufacturer and in the original packaging of this product. If you have any questions, please do not hesitate to contact us.

Explanation of the Symbols on the Product Label

DC voltage: Indicates the device operates on Direct Current voltage.

Indoor use only: This device is intended for indoor use only.

Recycling (WEEE)

This product bears the selective sorting symbol for Waste Electrical and Electronic Equipment (WEEE). This means the product must be handled according to European directive 2012/19/EU to be recycled or dismantled to minimize its environmental impact. Users can choose to give their product to a competent recycling organization or the retailer when buying new electrical or electronic equipment.

Support

For technical support, the user guide, and more information, please visit http://www.mercusys.com/en/support.