Installation & Usage Guide
This guide provides step-by-step instructions for installing the Conceptronic EMRICK03G 4-Port SATA PCIe Adapter.
Installation Steps:
- Turn Off the power to your computer.
- Unplug the power cord and remove your computer's cover.
- Remove the slot bracket from an available PCIe slot.
- To install the card, carefully align the card's bus connector with the selected PCIe slot on the motherboard. Push the board down firmly.
- Replace the slot bracket's holding screw to secure the card.
- Replace the computer cover and reconnect the power cord.
Driver Installation:
After physical installation, your computer may display a "New Hardware Wizard" message. This can be ignored by clicking "Cancel".
- Insert the CD-ROM included with the adapter into your computer's optical drive. The AutoPlay option should appear automatically.
- Click on "Run Autorun.exe" to launch the autorun menu.
- Select "Install Drivers" and follow the on-screen instructions to install the necessary drivers for the serial PCIe card.
- Once the driver installation is complete, restart your computer to ensure the drivers are loaded correctly.
Note: CONCEPTRONIC® is a registered trademark of Digital Data Communications GmbH. Copyright Digital Data Communications GmbH. All Rights Reserved.