Naim Audio Safety Manual and Compliance Information

Introduction

This document includes statutory safety instructions and statements, guarantee information, and a CE Declaration of Conformity. Please read this document carefully before installing your new unit.

Important Safety Instructions

1. In order to comply with current European safety regulations it is essential that the Naim loudspeaker connectors supplied with amplifiers and loudspeakers are used.
2. Do not under any circumstances allow anyone to modify your Naim equipment without first checking with the factory, your retailer, or your distributor. Unauthorised modifications will invalidate your guarantee.
3. Equipment must not be exposed to dripping or splashing and no objects filled with liquid, such as vases, should be placed on the equipment.
4. For your own safety do not under any circumstances open Naim equipment without first disconnecting it from the mains power supply.
5. Warning: an apparatus with CLASS 1 construction shall be connected to a mains socket outlet with a protective earthing connection.
6. Warning: batteries installed shall not be exposed to excessive heat such as sunshine, fire or the like.
7. Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. To disconnect the equipment from the mains remove the mains plug from the mains outlet.
8. This equipment has been tested and found to comply with the relevant EMC and Safety Standards, and, where applicable, also complies with limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
   • Reorient or relocate the receiving antenna.
   • Increase the separation between the equipment and receiver.
   • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
   • Consult the dealer or an experienced radio/TV technician for help.
9. In some territories a mains plug may need to be fitted to the supplied mains lead. As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in the plug proceed as follows:
   • The wire coloured GREEN-AND-YELLOW must be connected to the terminal in the plug marked by the letter E or by the safety earth symbol or coloured GREEN or GREEN-AND-YELLOW.
   • The wire coloured BLUE must be connected to the terminal in the plug marked with the letter N or coloured BLACK.
   • The wire coloured BROWN must be connected to the terminal in the plug marked with the letter L or coloured RED.

Important Notes and Declarations

Note: To the fullest extent permitted by applicable law, Naim Audio Ltd. disclaims all liability for any loss or damages whether real, incidental or consequential that arise from using this product. Naim Audio Limited, it's agents and representatives, cannot be held responsible for the loss of any data or content from a Naim server, however caused.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Only operate the device in accordance with the instructions supplied. This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

IC Statement

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This advice may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure. Users can obtain Canadian information on RF exposure and compliance. This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This Class B digital apparatus complies with Canadian ICES-003.

CE Declaration of Conformity

Naim Audio declares that Naim Audio products are in conformance with:

• 2014/35/EU - Low voltage Directive (LVD)
• 2014/30/EU - Electromagnetic Compliance Directive (EMC)
• 2014/53/EU - Radio Equipment Directive (RED)
• 2011/65/EU - Restriction of Hazardous Substances Directive (RoHS)
• 2012/19/EU - Waste of Electrical and Electronic Equipment (WEEE)
• 2009/125/EC - Energy Related Product Directive (ErP)

Naim Audio products comply with the following standards:

• EN 60065 - Audio and Video and similar electronic apparatus
• IEC62368-1 - Audio/video, information and communication technology equipment - Part 1: Safety requirements (Uniti Atom Headphone Edition)
• EN 55032 - Electromagnetic compatibility of multimedia equipment - Emissions requirements
• EN 55020 - Sound and television broadcast receivers and associated equipment - Limits and methods of measurement
• EN 61000-3-2 - Mains Harmonics current emissions
• EN 61000-3-3 - Mains Harmonics current emissions

Under UK PSTI regulation, you can find our Statement Of Compliance on https://www.naimaudio.com/declarations-of-conformity - section Statement Of Compliance.

Other Languages

This document also provides safety instructions and compliance information in German, French, Dutch, Spanish, Italian, Portuguese, Polish, Russian, and Chinese.

Designed and manufactured by Naim Audio, Salisbury, England.