Micro-Mark Tools - Precision Tools and More for Makers
Instruction Manual for Micro-Mark models including: 82088 Jig Scroll Saw Cross Saw Gourd Saw, 82088, Jig Scroll Saw Cross Saw Gourd Saw, Scroll Saw Cross Saw Gourd Saw, Saw Cross Saw Gourd Saw, Cross Saw Gourd Saw, Saw Gourd Saw, Gourd Saw, Saw
Product Instructions – Micro-Mark
File Info : application/pdf, 1 Pages, 2.32MB
DocumentDocumentCRANKPIN REPLACEMENT INSTRUCTIONS FOR #15226 JIG / SCROLL SAW & #82088 CROSS SAW / GOURD SAW STEP 1 Use screwdriver to pry off the cover. STEP 2 Rotate crankpin until shaft is pulled in as far as possible. If separated from link, push shaft in as far as possible. STEP 3 Remove the collar from the shaft with a proper-fitting flat blade screwdriver or hex wrench as required. STEP 4 Remove four screws holding crankcase. STEP 5 Remove crankcase and rotate plastic link as shown so that shaft can be removed. Note: If link and shaft are already separated because pin fell out, remove link, shaft and pin. STEP 6 Note replacement link has bearing which protrudes on side away from motor. Install all parts in reverse order from disassembly. STEP 7 Final adjustment: Run the saw and adjust the "tightness" of each of the four crankcase screws so that the saw runs freely (without loading down). STEP 8 Note that set screw on collar should be positioned at 90° from slot in shaft. STEP 9 340 Snyder Avenue, Berkeley Heights, NJ 07922 Tech Support: Tech@micromark.com www.micromark.com MM050222