DJI Mavic 3 Pro Safety Guidelines
Version: v1.0
This document provides essential safety guidelines, operating instructions, and technical specifications for the DJI Mavic 3 Pro. By using this product, you signify that you have read, understood, and accepted the terms and conditions outlined herein and in the full user manual available at dji.com/mavic-3-pro/downloads.
Safety at a Glance
Disclaimer: This product is not intended for children.
1. Flight Environment
- WARNING: DO NOT use the aircraft in severe weather conditions including heavy wind exceeding 12 m/s, snow, rain, fog, hail, or lightning.
- WARNING: DO NOT take off from an altitude more than 6,000 m (19,685 ft) above sea level.
- WARNING: DO NOT fly the aircraft in environments where the temperature is below -10° C (14° F) or above 40° C (104° F).
- WARNING: DO NOT take off from moving objects such as cars, ships, and airplanes.
- WARNING: DO NOT fly close to reflective surfaces such as water or snow. Otherwise, the vision system may be limited.
- WARNING: When the GNSS signal is weak, fly the aircraft in environments with good lighting and visibility. Low ambient light may cause the vision system to work abnormally.
- WARNING: DO NOT fly the aircraft near areas with magnetic or radio interference, including Wi-Fi hotspots, routers, Bluetooth devices, high-voltage lines, large scale power transmission stations, radar stations, mobile base stations, and broadcasting towers.
- WARNING: When flying at a high altitude, pay attention to environmental changes such as cloud cover, air currents, and low temperatures to avoid impacting the battery and power performance, which may cause an accident.
- NOTICE: Be careful when taking off in the desert or from a beach to avoid sand entering the aircraft.
- NOTICE: Fly the aircraft in open areas. Buildings, mountains, and trees may block the GNSS signal and affect the on-board compass.
2. Flight Operation
- WARNING: Stay away from rotating propellers and motors.
- WARNING: Make sure the aircraft batteries, remote controller, and the mobile device are fully charged.
- WARNING: Be familiar with the selected flight mode and understand all safety functions and warnings.
- WARNING: When flying at a high altitude, keep a safe distance from other aircraft and fly carefully to avoid collisions.
- NOTICE: Make sure DJI™ Fly and aircraft firmware have been updated to the latest version.
- NOTICE: Land the aircraft in a safe location when there is a low battery or high wind warning.
- NOTICE: Use the remote controller to control the speed and altitude of the aircraft to avoid collisions during Return-to-Home.
3. Battery Safety Notice
- WARNING: Keep batteries clean and dry. DO NOT allow liquid to come into contact with the batteries. DO NOT leave batteries covered in moisture or out in the rain. DO NOT drop the batteries into water. Otherwise, an explosion or fire may occur.
- WARNING: DO NOT use non-DJI batteries. It is recommended to use DJI chargers.
- WARNING: DO NOT use swollen, leaking, or damaged batteries. In such situations, contact DJI or a DJI authorized dealer.
- WARNING: The batteries should be used at a temperature between -10° C (14° F) or above 40° C (104° F). A high temperature can cause an explosion or fire. A low temperature will reduce the performance of a battery.
- WARNING: DO NOT disassemble or pierce the battery in any way.
- WARNING: The electrolytes in the battery are highly corrosive. If any electrolytes come into contact with your skin or eyes, immediately wash the affected area with water and seek medical support.
- WARNING: Keep batteries out of the reach of children and animals.
- WARNING: DO NOT use a battery if it is involved in a crash or heavy impact.
- WARNING: Extinguish any battery fire using water, sand, or a dry powder fire extinguisher.
- WARNING: DO NOT charge the battery immediately after flight. The battery temperature may be too high and may cause serious damage to the battery. Allow the battery to cool down to close to room temperature before charging. Charge the battery at a temperature range of 5° to 40° C (41° to 104° F). The ideal charging temperature range is 22° to 28° C (72° to 82° F). Charging at the ideal temperature range can prolong battery life.
- WARNING: DO NOT expose the battery to fire. DO NOT leave the battery near heat sources such as a furnace, heater, or inside a vehicle on a hot day. Avoid storing the battery in direct sunlight.
- WARNING: DO NOT store the battery for an extended period after fully discharging. Otherwise, the battery may over-discharge and cause irreparable damage to the battery cell.
- WARNING: If a battery with a low power level has been stored for an extended period, the battery will enter deep hibernation mode. Recharge the battery to bring it out of hibernation.
Specifications
Aircraft (Model: L2S)
| Parameter | Value |
|---|---|
| Operating Temperature | -10° to 40° C (14° to 104° F) |
| O3+ Operating Frequency | 2.400-2.4835 GHz, 5.725-5.850 GHz |
| O3+ Transmitter Power (EIRP) | 2.4 GHz: <33 dBm (FCC), <20 dBm (CE/SRRC/MIC) 5.8 GHz: <33 dBm (FCC), <14 dBm (CE), <30 dBm (SRRC) |
| Wi-Fi Protocol | 802.11b/a/g/n/ac/ax, Wi-Fi with 2×2 MIMO |
| Wi-Fi Operating Frequency | 2.400-2.4835 GHz, 5.725-5.850 GHz |
| Wi-Fi Transmitter Power (EIRP) | 2.4 GHz: <20 dBm (FCC/CE/SRRC/MIC) 5.8 GHz: <23 dBm (FCC/SRRC), <14 dBm (CE) |
| Bluetooth Protocol | Bluetooth 5.1 |
| Bluetooth Operating Frequency | 2.400-2.4835 GHz |
| Bluetooth Transmitter Power (EIRP) | <8 dBm |
Remote Controller (Model: RM330)
| Parameter | Value |
|---|---|
| Operating Temperature | -10° to 40° C (14° to 104° F) |
| Max Transmission Distance (Unobstructed, free of interference) | 15 km (FCC), 8 km (CE/SRRC/MIC) |
| O3+ Operating Frequency | 2.400-2.4835 GHz, 5.725-5.850 GHz |
| O3+ Transmitter Power (EIRP) | 2.4 GHz: <26 dBm (FCC), <20 dBm (CE/SRRC/MIC) 5.8 GHz: <26 dBm (FCC), <14 dBm (CE), <23 dBm (SRRC) |
| Wi-Fi Protocol | 802.11a/b/g/n |
| Wi-Fi Operating Frequency | 2.400-2.4835 GHz, 5.150-5.250 GHz, 5.725-5.850 GHz |
| Wi-Fi Transmitter Power (EIRP) | 2.4 GHz: <23 dBm (FCC), <20 dBm (CE/SRRC/MIC) 5.1 GHz: <23 dBm (FCC/CE/SRRC/MIC) 5.8 GHz: <23 dBm (FCC/SRRC), <14 dBm (CE) |
| Bluetooth Protocol | Bluetooth 4.2 |
| Bluetooth Operating Frequency | 2.400-2.4835 GHz |
| Bluetooth Transmitter Power (EIRP) | <10 dBm |
Intelligent Flight Battery
| Parameter | Value |
|---|---|
| Capacity | 5000 mAh |
| Standard Voltage | 15.4 V |
| Charging Temperature | 5° to 40° C (41° to 104° F) |
Compliance Information
This product complies with various regulations including FCC, ISED, and EU directives. For detailed information, please refer to the official DJI website and the full user manual.
Key compliance highlights include:
- FCC Compliance: This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: no harmful interference and acceptance of any interference received.
- ISED Compliance: This device complies with Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
- EU Compliance: DJI Mavic 3 Pro complies with essential requirements and relevant provisions of Directive 2014/53/EU. A copy of the EU Declaration of Conformity is available online at www.dji.com/euro-compliance.
- RF Exposure Information: The aircraft and remote controller comply with FCC and ISED radiation exposure limits. Specific operating instructions must be followed to ensure compliance.
For detailed compliance information, including specific regional requirements and declarations, please consult the full documentation available on the DJI website.
