Replacement Remote for Security+ Family / Billion Code Installation Manual
Programming Instructions for Garage Door Opener
Step 1: Locate the Smart / Learn Button
Locate the Smart / Learn button on your garage door opener. You will need a ladder to access it.
Diagram Description: Illustration of a garage door opener system, showing the motor unit mounted on the ceiling, tracks, and a ladder positioned nearby, indicating the need to reach the opener unit.
Step 2: Check the Working Mode on Remote
The remote has two working modes for different garage door opener types.
To check the working mode: Just press and hold the button. Then observe LED status.
| LED Status | Mode # | For Opener Type |
|---|---|---|
| SOLID | Mode 1 | Purple/ Red/Orange |
| FLASHING | Mode 2 | Yellow/ Green |
Check above table: Does the remote button's working mode match your opener's learn button color (as seen in Step 1)?
- If yes, proceed to Step 3.
- If no, you will need to change working mode first; proceed to Step 4.
Diagram Description: Illustration of a hand pressing and holding a button on a garage door remote. Accompanying text explains to observe the LED status. A table details LED status (SOLID, FLASHING) with corresponding Mode numbers (Mode 1, Mode 2) and Opener Types (Purple/Red/Orange, Yellow/Green).
Step 3: Garage Door Opener Learning
Press the learn button on the back of the opener. After the learn LED glows steadily, press and hold the button on the remote until the opener lights flash or you hear two clicks. At that point, the remote is successfully programmed.
Diagram Description: Illustration of the back of a garage door opener motor unit, highlighting the 'Learn Button' and 'Learn LED'. Text indicates audible 'Click Click' sounds during programming.
Step 4: Change the Working Mode on Remote
1. Using the Visor Clip to press and hold the "PROG" button on the back of the remote for 3 seconds until the LED flashes, then release.
2. Press and release the button of the remote; the LED will change to either SOLID (Mode 1) or FLASHING (Mode 2). Then try programming it again with the opener (step 3).
Diagram Description: Two illustrations demonstrating how to change the remote's working mode. The first shows a visor clip being used to press the 'PROG' button on the remote. The second shows a button press on the remote, resulting in its LED changing from SOLID to FLASHING or vice-versa.
Troubleshooting
?️ Automatically deactivated old remote? If your opener's memory is full, try erasing the garage opener's memory according to the motor unit owner's manual, and then reprogram.
? It stopped working after a few weeks: Replace the CR2032 Battery when the remote stops working after a few weeks.
? Have garage door closed first: Sometimes, the door must be closed before programming.
? The Learn LED glow steadily: Ensure that the Learn LED glows steadily when performing Step 3.