Ozotech EOG 200 Cartridge Dryer Installation Instructions
Safety Information
WARNING! High Voltage!
Be sure to disconnect power to the EOG 200 unit before servicing.
Components and Diagram Description
The illustration details the components and assembly for the Ozotech EOG 200 Cartridge Dryer. It features the EOG 200 Enclosure, shown with its cover removed. For mounting the dryer canister, a Canister Holder Clip is provided, along with an O-Ring Flexible Spacer and two Self Drilling / Tapping Truss Head Screws. A Replaceable Dryer Canister is also depicted. An advisory note states: 'Replace cartridge when color turns pink.' The Ozotech logo, identifying the manufacturer as a Clack Corporation Company, is present.
Installation Steps
- Using a cordless drill or powered screwdriver, install screw through canister clip; lightly tighten.
- Slide O-ring under clip and align with lower hole dimple.
- Install second screw through clip and O-ring. Tighten screws so clip is solid and canister is held vertically.
- Remove enclosure cover of EOG, if not done already.
- Remove original clear intake hose from CD cell and discard.
- Install the supplied longer intake hose to CD cell and route out and around the back of the enclosure.
- Remove the cap covering the canister's barbed fitting and attach the intake tube to it.
