Xiaomi Mi Selfie Stick Tripod
Instructions
Remote Shutter Installation
Open the packaging and mount the remote shutter onto the rubber part of the stick.
Bluetooth Pairing
Activate your phone's Bluetooth function and find "XMZPG" to pair. When the light stops flashing and becomes solid blue, pairing is complete.
Phone Holder Opening
Hold the stick with the front facing upwards and open the phone holder to 90°, then rotate it 180° so it faces you. Ensure the camera button faces upwards.
Phone Placement
Rotate the phone holder to an appropriate position, extend the stick, and then secure the phone onto the holder.
Tripod Configuration
Open the tripod from the bottom and place it on a level surface.
Diagram Description: A diagram shows the selfie stick extended with a phone mounted. It illustrates the rotatable phone holder (360°, suitable for phones 56-89mm wide) and the extendable stick. Another smaller diagram shows the remote control with a 360° rotation indicator.
Removable Bluetooth Remote Control
- Removable Bluetooth remote control with a wireless range of 10 m.
- The charging port is located at the top of the remote control.
Functions
| Function | Description |
|---|---|
| Bluetooth Name | XMZPG |
| Charging | The camera button flashes red when the battery is low and needs recharging. The light remains red during charging and turns solid blue once charging is complete. |
| Camera | The camera button lights up blue to indicate it is ready for shooting. |
| Taking Photos | Press the camera button. |
| Power On for Pairing | Press and hold the camera button for 2 seconds to turn on the remote shutter and pair it. |
| Power Off | Press and hold the camera button for 3 seconds to turn off the remote shutter. |
| Paired | The camera button lights up blue. |
| For Pairing | The camera button flashes blue. |
| Sleep Mode | If pairing fails, the remote shutter enters sleep mode after 10 minutes. The indicator light dims to 20% brightness and stops flashing. It does not turn off in sleep mode. |
| Exit Sleep Mode | Press the camera button to exit sleep mode and restore brightness to 100%. Upon exiting sleep mode, the remote shutter will pair with the last connected device. The blue indicator light will illuminate if pairing fails. |
| Connection Lost | When the remote shutter loses connection to your phone due to excessive distance or other reasons, it enters sleep mode. |
| Pairing and Shooting While Charging | The remote shutter functions even while charging. |
Precautions
CAUTION:
Any alteration or modification not expressly approved by the warranty of this device may void the user's right to operate the device.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Regulatory Notice for U.S. Users
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Compliance Marks: CE, WEEE disposal symbol (crossed-out wheelie bin), Bluetooth logo.
FCC ID: 2AJ7P-ZPG01YM
