BVK-3317
Multiple Function RGB Light Wireless Speaker
Components
- Wireless Speaker*1
- Charging Cable*1
Specifications
Wireless transmission range | up to 10 meters |
Speaker drive size | 3inch*2 |
Output power | 10W |
Frequency response | 100Hz-20KHz |
Signal to noise ratio | ≥85dB |
FM scan range | 87.5-108.0MHz |
USB charging | TYPE-C |
Product size | 16*15.2*29.2 CM |
Key Manual / Button Functions
The device features several controls for operation:
- LED LIGHT MODE: Controls the RGB lighting modes.
- MODE: Switches between different operational modes (e.g., Bluetooth, FM Radio, Line In, TF Card, USB).
- PREVIOUS SONG/VOL-: Short press to select the previous song or radio station. Long press to decrease volume.
- PLAY/PAUSE: Short press to play or pause music, or to answer/end calls. Long press may initiate TWS pairing.
- NEXT SONG/VOL+: Short press to select the next song or radio station. Long press to increase volume.
- LINE IN/TF CARD: Port for connecting external audio devices via a line-in cable or for inserting a TF (microSD) card for media playback.
- TYPE-C/ON/OFF: USB Type-C port for charging the device. Also serves as the main power ON/OFF switch.
- USB/MICROPHONE: USB port for media playback from a USB drive and a microphone input port.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Modifications
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
FCC Compliance Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.