Silonn Ice Maker Instruction Manual
Model Numbers: SLIM17B, SLIM17T, SLIM17G1, SLIM17G
Important Safety Information
To reduce the risk of injury or property damage, please follow these safety precautions.
⚠️ WARNING
- ⚡ Voltage power from outlet must match specifications on appliance nameplate.
- ? This appliance must be grounded.
- Using an extension cord may cause overheating and increase the risk of fire. If an extension cord MUST be used: 1) Only use an extension cord with grounding plug. 2) The marked rating of an extension cord must be equal to or greater than the rating of this appliance.
- ❌ Do not operate if any component, including the cord or plug, is damaged.
- ✋ Unplug the unit before cleaning by hand.
- Only responsible and capable adults should operate the ice maker.
- ? Do not place the power cord where it could be pulled by children or pose a tripping hazard.
- Children should not be left unattended near the ice maker during operation.
- ? Do not use water that is micro-biologically unsafe or of unknown quality.
- ?️ Do not remove any safety, warning, or product information labels from the unit.
- ❄️ Do not touch the evaporator with your hands while the ice maker is operating.
- ?✋ Do not plug in or unplug the unit with wet hands.
- The unit must be placed and set up according to installation instructions before use. The unit is for indoor household use only.
- ? Do not store or use flammable vapors or liquids near the unit.
- ? Do not immerse any part of the unit in water.
- ? Do not attempt to disassemble, repair, modify or replace any part of the ice maker without permission from Silonn or its affiliates.
⚠️ WARNING: FIRE OR EXPLOSION HAZARD Flammable Refrigerant
This unit contains an isobutane refrigerant, also known as R600a, a natural gas with high environmental compatibility. However, it is also combustible. Adhere to the warnings below to reduce the risk of injury or property damage.
- When handling, installing, and operating the unit, care should be taken to avoid damage to the refrigerant tubing.
- Only dispose of the unit according to Federal and Local Regulations. Contact your local authorities for the environmentally safe disposal of the unit.
- ? Keep ventilation openings around the unit's enclosure clear of obstruction.
- ? Do not place the unit near heat sources such as an oven.
- Ensure a minimum of three inches of clearance around the side and back walls of the unit for proper air circulation.
- ☀️ Do not place the unit in direct sunlight.
Product Introduction
Tip: To pull off the cover, place your fingers in the opening under the left side.
Diagram Description: An illustration of the Silonn Ice Maker. The removable top cover is shown open, with an arrow indicating how to lift it. The main unit displays labels for various components. Separate illustrations show the ice basket and ice scoop. The components are identified as:
- 1. Removable Top Cover
- 2. Secondary Water Reservoir
- 3. Ice Full Sensor
- 4. Ice Outlet
- 5. Water Reservoir
- 6. Control Panel
- 7. Air Exhaust Fan
- 8. Drain Plug
- 9. Maximum Water Fill Line
- 10. Filter
- 11. Ice Basket
- 12. Ice Scoop
Control Panel Introduction
The control panel features indicator lights and a button to manage the ice maker's functions.
| Key (with indicator light) | Function |
|---|---|
| 1. ICE FULL | The indicator light turns red when the ice basket is full. |
| 2. ADD WATER | The indicator light turns red when the water reservoir needs water. |
| 3. ICE/CLEAN |
|
Using Your Ice Maker
Before First Use
- Stand upright for 24 hours. Check for accessories.
- Use in locations with ambient temperatures between 10°C and 32°C (50°F and 90°F).
- Diagram Description: Three illustrations are provided. The first shows the ice maker standing upright with "24Hrs" indicated. The second shows a thermometer displaying 10°C ~ 32°C, with ice cubes and the text "More Cycles = Perfect Shape". The third illustration shows three "X" marks indicating prohibited conditions: an unstable base, using liquids other than water (drinking water only), and operating in high or low temperatures (below 41°F/5°C or above 90°F/32°C).
- Missing parts? Contact Silonn Customer Service.
What Not To Do!
- ❌ Unstable base.
- ❌ No other liquids (Drinking water only).
- ❌ Do not use in high or low temps.
How to Use Your Ice Maker
- Open cover and remove basket.
- Pour water, do not exceed the "MAX" water mark.
- Press the “ICE/CLEAN” button.
- Wait 6-8 minutes. (This time may vary depending on room and water temperature).
- Diagram Description: A step-by-step visual guide. Step 1 shows the ice maker with the cover open and basket removed. Step 2 illustrates pouring water into the reservoir up to the "MAX" fill line. Step 3 shows a finger pressing the "ICE/CLEAN" button on the control panel. Step 4 displays a clock icon indicating a 6-8 minute wait time, with a note about temperature dependency. The final images show the control panel indicators: one indicating "Done" with the "ICE FULL" light on, and another indicating "Refill" with the "ADD WATER" light red.
Ice is full and ready when the “ICE FULL" indicator is on.
When the "ADD WATER" indicator is red, add water and press “ICE/CLEAN".
Cleaning and Maintenance
To keep your ice tasting fresh and the unit looking great, it is recommended to clean the unit once per week.
Manual Cleaning
- Remove the top cover and basket.
- Clean both water reservoirs using a soft cloth dampened with warm water and vinegar, then rinse with clean water.
- Drain Plug: Remove the drain plug to drain excess water over a sink. Ensure at least 60mm clearance from the working table for drainage.
- Clean exterior with a cloth and mild dishwashing soap.
Self-Cleaning (15-Minute Process)
- Remove the basket and add water up to the "MAX" water level.
- In Standby Mode, hold the “ICE/CLEAN” button for 5 seconds to start self-cleaning.
- Drain Plug: Remove the drain plug to drain excess water over a sink. Ensure at least 60mm clearance from the working table for drainage.
- Clean exterior with a cloth and mild dishwashing soap.
Additional Cleaning Notes:
- Do not use organic solvent, boiled water, detergent, strong acid, or strong alkali for cleaning.
- When the unit is not to be used for a long duration, drain the water completely and dry the interior.
- Store in a well-ventilated area.
Product Specifications
| Specification | SLIM17B/SLIM17G1/SLIM17G | SLIM17T |
|---|---|---|
| Model | SLIM17B/SLIM17G1/SLIM17G | SLIM17T |
| Voltage/Frequency | 115V/60Hz | 115V/60Hz |
| Ice-making Current | 2.7A | 2.7A |
| Water Reservoir | 1.1L | 1.1L |
| Ice Basket Capacity | 1.76 lbs (0.8KG) | 1.76 lbs (0.8KG) |
| Ice-making Rate | 33 lbs per day | 33 lbs per day |
| Ice Shape | Nugget | Nugget |
| Material | ABS, PP | ABS, PP, Stainless Steel |
| Net Weight | 17.6 lbs (8KG) | 17.6 lbs (8KG) |
| Product Size | 11.3 x 8.66 x 12.68 inch (287 x 220 x 322mm) | 11.3 x 8.66 x 12.68 inch (287 x 220 x 323mm) |
Troubleshooting
| Problem | Possible Causes | Solution |
|---|---|---|
| "ADD WATER" light is on. | Low water level or not enough water. | Stop making ice, refill water, press “ICE/CLEAN", then restart and try again. |
| "ICE FULL" light is on. | There is too much ice. | Remove some ice. |
| "ICE FULL" light is on. | If there are no ice cubes, there may be an obstruction or the inner wall needs cleaning. | Remove the obstruction inside or clean the inner wall of the ice storage. |
| Ring indicator light flashes in red. | The ambient temperature or the water temperature in the inner tank is too high. | Please run the ice maker when the ambient temperature is below 90°F (32°C) and pour colder water into the tank. |
| Ring indicator light flashes in red. | Refrigerant liquid leakage. | Press the ICE button twice to restart the ice-making program. If this problem shows up again, please contact customer service. |
| Ring indicator light flashes in red. | The cover motor is broken. | Please contact customer service. |
| Ring indicator light flashes in red. | The pipe in the cooling system is blocked. | Please contact customer service. |
| Making Ice too slowly. | Hot air outlet has been blocked by something. | Hot air outlet must be guaranteed to have more than 5.9 inches of ventilation distance. |
| Making Ice too slowly. | The water temperature in the inner tank is too high. | Water temperature requirement between 7°C - 32°C. |
| Making Ice too slowly. | Refrigeration system malfunctions. | Please contact customer service. |
| Water leakage. | The drain plug is not in place. | Put the drain plug in place. |
| Water leakage. | Pipe joints in the appliance may loose. | Please contact customer service. |
| Water leakage. | The seal has reached the end of its service life. | Please contact customer service. |
Short and Long-Term Warranty Information
30-Day Limited Warranty
To provide customers with a quality shopping and user experience, the unit can be replaced or returned for a full refund within the 30-day period from the date of purchase.
30-Day to 1-Year Limited Warranty
After the 30-day warranty has expired, Silonn automatically activates a 1-year warranty from the date of purchase that covers product replacement.
30-Day to 1-Year Warranty Limitations
This warranty does not cover:
- Any condition resulting from incorrect or inadequate maintenance or care.
- Damage resulting from misuse, abuse, negligence, accidents, or shipping damage.
- Dissatisfaction due to buyer's remorse.
- Normal wear and tear.
- Damages incurred after initial transportation.
Document Reference: 860-00640-00 Rev00
