Danfoss Climate Solutions for heating | Efficient solutions for superior comfort | Danfoss
Installation Guide for Danfoss models including: RLV-D Angled Lockshield, RLV-D, RLV-D Lockshield, Angled Lockshield, Lockshield
File Info : application/pdf, 4 Pages, 556.41KB
DocumentDocumentRLV-D Installation Guide Specification Compression Push-fit Copper pipe: According to BS2871 Part 1 / BS EN1057. Max. temp. 120°C, Max. pressure 10 bar Copper pipe: According to BS2871 Part 1 / BS EN1057. Max. temp. 92°C, Max. pressure 3 bar Plastic pipes: According to BS7291. Max. temp. 92°C. Max. pressure 3bar Cutting the pipes 1.Cut the pipe square ensuring that it is free from score marks and burs. For plastic pipe we recommend the use of a plastic pipe cutter, do not use a hacksaw 2.For plastic pipes, it is essential that a pipe insert is used. This must be of the same make as the pipe. It is important to ensure that all internal burs are removed from the pipe end prior to fitting the insert. Do not use any lubricant. Mounting - Compression 1. Ensure the pipe is pushed to the pipe 2. stop IMPORTANT: Both nuts have to be tightened Mounting - Push-fit 1. Ensure the pipe is pushed to the pipe stop in the elbow 2. IMPORTANT: Both nuts have to be tightened It is good practice to check the fitting before use: pull the pipe back to check it is secure Dismounting: ensure system is de-pressurised. Push collet squarely into elbow and firmly pull out pipe Isolation and Regulation Removal of protective cap Isolation Regulation 6mm Allen key Turn til stop Turn back: ¼ - 4 rev. Danfoss A/S Heating Climate Solutions · heating.danfoss.com · +45 7488 2222 · E-mail: heating@danfoss.com Any information, including, but not limited to information on selection of product, its application or use, product design, weight, dimensions, capacity or any other technical data in product manuals, catalogues descriptions, advertisements, etc. and whether made available in writing, orally, electronically, online or via download, shall be considered informative, and is only binding if and to the extent, explicit reference is made in a quotation or order confirmation. Danfoss cannot accept any responsibility for possible errors in catalogues, brochures, videos and other material. Danfoss reserves the right to alter its products without notice. This also applies to products ordered but not delivered provided that such alterations can be made without changes to form, fit or function of the product. All trademarks in this material are property of Danfoss A/S or Danfoss group companies. Danfoss and the Danfoss logo are trademarks of Danfoss A/S. All rights reserved. AN000086406205en-010102 - Part No. 013R9670 © Danfoss Climate Solutions | 01.2023