Instruction Manual for VISTA PROFESSIONAL OUTDOOR LIGHTING models including: STM-D Commercial Series Double Stanchion Mount, STM-D, Commercial Series Double Stanchion Mount, Double Stanchion Mount, Stanchion Mount, Mount

STM-D-(Wall Mount)-Inst

Double Stanchion Mount


File Info : application/pdf, 1 Pages, 123.61KB

PDF preview unavailable. Download the PDF instead.

STM-D-(wall)-Inst
INSTALLATION INSTRUCTIONS

STM-D | Wall Mount
Commercial Series

WARNING: STM-D Stanchion Mount Single must be installed and grounded in accordance with the National Electrical Code (NEC) and local codes. Failure to do so will void the warranty and may result in serious injury and or damage to the luminaire Stanchion Mount. NOTE: Always use UL Listed wire connectors for connections (by others). NOTE: Save these instructions for future reference.
LUMINAIRE FITTING ­ STANCHION MOUNT IS SUITABLE FOR WET LOCATIONS

STANCHION MOUNTING TO STRUCTURAL SURFACE OVER RECESSED 4-0 BOX ( by others) OR CONDUIT STUB OUT
1. Make sure electrical supply is off at circuit breaker before starting stanchion mount installation.
2. Install 3/8" read head style bolts (by others) on 6" centers over 4-0 box or conduit stub out.
BOLTS TO PROTRUDE 5/8" ­ 7/8" FROM WALL SURFACE 3. Pull electrical supply wiring through stanchion to top opening of stanchion. 4. Apply appropriate sealant along the base of the stanchion mount, secure
stanchion onto wall over red head style bolts. 5. Tighten fully stanchion washers and nuts onto base. 6. Apply sealant (by others) onto stanchion nut covers. Install nut covers into
stanchion base. 7. Thread fixture stem through stanchion mount cap. 8. Make electrical connections from supply service to fixture. Secure cap onto
stanchion using two ¼"-20 screws. 9. Aim fixture and secure. Energize fixture to test for proper operation.

6" Bolt Mount
Pattern

Thru Holes Suitable For
3/8" Bolts (Bolts By Others)

Wall
3/8" Red Head Mounting Bolts
(By Others)
Stanchion Nuts
Apply Sealant (By Others)
Around Base Of Stanchion
Bolts (By Others) To Be Mounted 5/8"-7/8"
From Wall Surface

Stanchion Mount
Stanchion Mount Cap Fixture

Vista Professional Outdoor Lighting reserves the right to modify the design and/or construction of the fixture shown without further notification.

www.VistaPro.com · email@vistapro.com · Fax: (888) 670-VISTA (8478) 1625 Surveyor Avenue · Simi Valley, CA 93063 · (805) 527-0987 · (800) 766-VISTA (8478)
Vista Professional Outdoor Lighting reserves the right to modify the design and/or construction of the fixture shown without further notification.

Page 1 of 1 REV 02.13.24



References

Adobe PDF Library 17.0 Adobe InDesign 18.1 (Macintosh)