Reelcraft Industries - Hose, Cord, and Cable Reels
Instruction Manual for REELCRAFT models including: 600873 Push Button Switch with Speed Control, 600873, Push Button Switch with Speed Control, Switch with Speed Control, Speed Control
Reelcraft 600873 Push Button Switch with Speed Control
Reelcraft 600873 - Push Button Switch with Speed Control
File Info : application/pdf, 1 Pages, 144.29KB
DocumentDocumentTech Bulletin 600873 Speed Control Installation Instructions 600873 Speed Control Install Instructions Revised: 2/22 Application: The 600873 is a Forward/Reverse Variable Speed Control and is specifically designed for the 115 Volt or the 230 Volt Universal Motors (Rectified DC Motors) with a Motor Tag Current Rating of no larger than 10 Amps. The control contains an internal rectifier, therefore the internal motor rectifier wires are not used. See wiring instructions. New Application Restriction: The control cannot be used for motor wires longer than 150 feet. The added inductance caused by the long motor wires is beyond the specs of this control. If you require a control with longer than 150 feet of motor wires, you must contact Reelcraft to acquire a "special application" control. Mounting: Screw holes in the enclosure flange or drill your own holes in the flange. Mount the control standing up; not flat on it's back. Wiring Instructions Before wiring the control, assure the direction rocker switch is in the "center off" position. Speed Control Slow Fast Wind (On)-Off Momentary Pushbutton 1/2 " Conduit Unwind Forward/Reverse Rocker Switch NOTE: If the motor direction is not correct, swap the motor wires with the speed control's two blue wires. Do not connect the motor's green ground wire to any of the control's wires. Connector Black (hot leg) Input Output 115 Volts DC Blue to motor wire Motor Wire #5 Reel 115 Volt AC White (neutral) Blue to motor wire Motor Wire #6 Motor Motor wires #1, #2, #3, #4 are not used when using the Speed Control. The rectification function is integrated in the speed control and these four motor wires are not required. Input Black (hot leg) 230 Volt AC White (hot leg) Output 230 Volts DC to Motor There is no voltage or current in these wires when the motor, or speed control, is operating. You may insulate these with electrical tape and secure these wires so they do not hinder the reel Make the wire connections in your own electrical box - Do not open the controller. There is no room in the controller to make your wire connections. Use aluminum conduit between the controller drive mechanism. and your electrical box. Circuit Protection - The installer must provide the 12 AWG, 2 conductor feed line and it must be on it's own circuit, protected by a 15 Amp circuit breaker in the electrical service panel. Do not use a ground fault breaker for the motor controller circuit protection. Reelcraft Industries, Inc. · 2842 E Business Hwy 30, Columbia City, IN 46725 Ph: 800-444-3134 / 260-248-8188 · Fax: 800-444-4587 / 260-248-2605 Customer Service: 855-634-9109 · reelcraft@reelcraft.com · www.reelcraft.com Form # TB0028 Rev: 4/2022