Wahoo KICKR ROLLR: Installation and App Pairing Guide

Box Contents

• A. Rear Tire Body
• B. Front Tire Gripper Body
• C. AC Power Adapter

Tools Required

#2 Phillips Screwdriver

Installation

1. Step 1: Unfold

   Raise the folding arm of the front body.

2. Step 2: Remove Screws

   Locate Phillips head screws on the front body directly underneath the wheelbase adjustment lever. Use a Phillips head screwdriver to remove the screws.

3. Step 3: Connect Front and Rear Body

   Lift the wheelbase adjustment lever on the front body. Insert the rear tire body into the front body, ensuring the rear body is inserted past the screw holes beneath the adjustment lever. Close the lever back into place.

4. Step 4: Secure Front and Rear Body

   Reinsert the Phillips head screws from Step 2 into the screw holes on both sides of the front body beneath the adjustment lever and tighten with a Phillips head screwdriver.

5. Step 5: Install Bike

   Place the front bike wheel onto the front body wheel block so that the front tire sits firmly on the wheel block. Rest the rear bike wheel onto the rollers of the rear body.

6. Step 6: Wheelbase

   Lift the adjustment lever. Slide the rear body until the rear tire contacts evenly on the two rollers. Close the lever back into place.

7. Step 7: Tire Gripper

   Rotate the adjustment knob to tighten the gripper and capture the bike wheel.

8. Step 8: Power Connection

   Use the included AC power adapter to connect the KICKR ROLLR to a standard wall outlet.

App Pairing

1. Step 1: Download App

   Download the Wahoo app by scanning the QR code (QR codes are excluded from this HTML output).

2. Step 2: Launch App

   Launch the Wahoo app.

3. Step 3: Navigate to Settings

   Navigate to Settings.

4. Step 4: Access Settings Tab

   Click on the Settings tab.

5. Step 5: Select Sensors/Devices

   Click on Sensors/Devices.

6. Step 6: Add New Sensor

   Click on Add new sensor.

7. Step 7: Follow Instructions

   Follow the app instructions.