Govee H618A RGBIC LED Strip Lights User Manual

Introduction

Thanks for choosing the Govee RGBIC LED Strip Lights. This product is equipped with a 5m RGBIC strip light and supports app, voice (Alexa/Google Assistant), and IR remote control. RGBIC is Govee's latest lighting display technology. With its advanced IC chips (independent control), each strip light segment can be adjusted independently, creating vibrant rainbow effects.

What You Get

• LED Strip Lights (1)
• Adapter (1)
• User Manual (1)
• Service Card (1)

At a Glance (Control Box Functions)

• Turn the light on/off. [Power Button]
• Press to cycle through 9 colors. [Color Cycle Button]
• Press to enter music mode. [Music Mode Button]
• Press and hold to cycle through 6 brightness levels. [Brightness Button]

Safety Instructions

Read and follow all the safety instructions:

• The product is not water resistant; be cautious when installing and using.
• Use the product with the provided power adapter only.
• Be cautious of static electricity during installation and usage. Keep the product away from sharp objects or strong corrosive chemicals.
• When bending the strip lights during installation, avoid folding the LED components as it may affect the product's life span.
• Remove nails, metal, or other conductive objects from the installation surface before attaching the strip light, as it may cause short-circuiting.
• Do not install the strip light near any heat sources.
• Do not allow children to install the strip light alone.
• Avoid installing the strip light near potentially dangerous sources (e.g., candles, liquid-filled objects).
• Unroll the strip lights before powering them on.

CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

ATTENTION : RISQUE D'EXPLOSION SI LA BATTERIE EST REMPLACÉE PAR UN TYPE INCORRECT. ÉLIMINER LES BATTERIES USÉES CONFORMÉMENT AUX INSTRUCTIONS.

Note: For indoor use only. (POUR UNE UTILISATION EN INTÉRIEUR UNIQUEMENT)

Installing Your Device

Before You Install

1. Unpack the box and check all items listed in the packing list.
2. Power on the strip light and check whether it lights up.

Installing Steps

Step 1: Wipe the surface to make sure it's clean and dry.

Step 2: Peel off the protective film on the tape, stick the strip on and press over it firmly.

Step 3: Peel off the protective film on the control box and stick it on. Place the control box close to the music source to achieve the best music effect.

Step 4: Power on the strip lights and start using.

Pairing Your Device with the Govee Home App

What You Need

• A Wi-Fi router supporting the 2.4GHz and 802.11 b/g/n bands. 5GHz is not supported.

Pairing Instructions

1. Download the Govee Home app from the App Store (iOS devices) or Google Play (Android devices). Visit www.govee.com/app for more information.
2. Turn on Bluetooth on your smartphone.
3. Open the app, tap the "+" icon in the top right corner and search for "H618A".
4. Tap the device icon and follow the on-screen instructions to complete pairing.

Controlling the Device with Your Voice

1. Open the app, then tap the device icon to enter the detail page.
2. Tap the setting icon in the top right corner.
3. Select "Using Guidance" and follow on-screen instructions to control the device using your voice.

Tips for Voice Control:

• Make sure you have entered the correct Wi-Fi name and password.
• Change your Wi-Fi password to a brief one (8 numbers and letters are suggested).
• Connect your phone's hotspot to the strip lights and check whether the router works with the strip lights.

Troubleshooting

1. Adhesive tape is not strong enough.
   • Make sure the installation surface is clean and dry.
   • Firmly press over the strip after sticking.
   • Reinforce the installation via more clips and tape.
2. Cannot connect to Bluetooth.
   • Do not skip Bluetooth connection in the app.
   • Ensure Bluetooth on your smartphone has been turned on.
   • Your smartphone may be incompatible with the Govee Home app. Try using a different smartphone then reconnect.
   • Power the strip lights and your smartphone Bluetooth off then on, then try again.
   • Ensure that your smartphone is within 1m/3.28ft of the strip lights when connecting.
   • Clear any obstructions that are between the strip lights and your smartphone.
3. The strip lights do not display the full selected color / Some LED beads do not light up.
   • Please contact the Govee support team for rapid product replacement.
4. Cannot sync the strip lights to the beat of my music.
   • Move the control box closer to the music source.
   • Clean the mic on the control box then try again.
5. Cannot connect to Wi-Fi.
   • Do not skip the Wi-Fi connecting steps in the app.
   • 5GHz network is not supported. Please set the router to 2.4GHz and then reset it.
   • Connect your phone to Wi-Fi and check whether the network works well.
6. Cannot connect to Alexa.
   • Pull out every connective part of the strip lights and firmly re-connect them.
   • Re-connect your phone to Wi-Fi.
   • Plug out the adapter port and re-plug it in.

Specifications

Customer Service

• Warranty: 12-Month Limited Warranty
• Support: Lifetime Technical Support
• Email: support@govee.com
• Official Website: www.govee.com
• Social Media: @Govee, @govee_official, @govee.official, @Goveeofficial, f @Govee.smarthome

Regulatory Information

FCC and IC Radiation Exposure Statement

This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

French: La distance entre l'utilisation et l'appareil ne doit pas être inférieure à 20 cm.

FCC and ISED Canada Statement

This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

French: Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil nedoit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-005.

French: Cet appareil numérique de la classe B est conforme à la norme NMB-005 du Canada.

Responsible party: Name: GOVEE MOMENTS (US) TRADING LIMITED, Address: 13013 WESTERN AVE STE 5 BLUE ISLAND IL 60406-2448, Email: support@govee.com, Contact information: https://www.govee.com/support

Note: This device uses a non-replaceable light source. When the light source reaches the end of its life cycle, this device should be replaced. Not intended for illumination. Only used for creating ambiance.

Instructions:

1. Do not connect the rope light to the supply while it is in the packing or wound onto a reel;
2. Do not use the rope light when covered or recessed into a surface;
3. Do not open or cut the rope light;