User Manual for TECNO models including: BG6S SPARK Go 2024 Smartphone, BG6S, SPARK Go 2024 Smartphone, Go 2024 Smartphone, 2024 Smartphone, Smartphone

Sanjeev

daishengsheng

Users Manual

TECNO MOBILE LIMITED BG6S 2ADYY-BG6S 2ADYYBG6S bg6s

PDF preview unavailable. Download the PDF instead.

GetApplicationAttachment.html?id=6907815
SPARK Go 2024
User Manual

Explosion diagram specification

1 FL(CTP+LCM) 3 F HSG ASM 5 PS LENS 7 F CAM 9 R CAM 8W 11 PS RUBBER 13 PCBA COPPER D 15 SCREW L3.5 17 R FLASHHOOD 19 R FLASH LENS 21 REC
23 BATTERY 25 PCBA SUB 27 EARPHONE RUBBER 29 USB RUBBER 31 SIDE KEY 33 SCREW L3.2 35 FP MYLAR 37 R FLASH DECO 39 R CAM 8W LENS

2 REC DECO 4 F FLASH HOOD 6 R CAM 8W AD 8 R CAM 13M 10 PCBA MB 12 SIM CARD HOLDER 14 MI HOUSING 16 BAT COVER ASM 18 R CAM DECO 13M 20 R CAM 13M LENS 22 RF CABLE
24 MOTOR LINEA 26 PCBA COPPER B 28 SPK 30 PCBA COPPER A 32 SPK CON CLOTH 34 R CAM 13M CON FOAM 36 FP 38 R CAM 8W DECO

Know your phone
1. Front camera 2. Volume + key 3. Volume - key 4. Power key & side fingerprint sensor

SIM/SD card installation
1. Power off mobile.
2. Refer to the following picture for SIM / SD card installation.

Charging the phone
You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone).
Use only TECNO charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.

FCC Caution
Labelling requirements.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operatio
Information to user. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information: This mobile phone meets the government's requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types:BG6s (FCC ID:2ADYY-BG6S) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.13 W/kg and when properly worn on the body is 0.72 W/kg.
Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user's body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

HiOS runs on AndroidTM OS. Android is a trademark of Google LLC.


Microsoft Office Word 2007 Microsoft Office Word 2007