Frigidaire Gallery Multi-Door Refrigerator

Before You Start

Set Up Your Refrigerator

Before turning on the refrigerator, remove all tape and glue residue from surfaces. Choose a location near a grounded electrical outlet, ensuring adequate clearances for proper installation, air circulation, and plumbing/electrical connections.

Before Operating for the First Time

[note]After removing all packaging materials, clean the interior of your refrigerator before use. Refer to the "CARE AND CLEANING" section in your Use & Care Manual for detailed instructions.

You're In Control

Your Appliance Control Display*

For optimal performance, set refrigerator temperatures to 37°F (3°C) and freezer temperatures to 0°F (-18°C). Allow 24 hours for temperatures to stabilize before adjusting further as needed.

*Control display models may vary. Consult your Use & Care Manual for specific details.

External Dispenser Control Display

This display allows you to manage various refrigerator functions:

• 1. Freeze Boost: Activate before grocery shopping to lower temperatures and freeze food faster. It remains active for up to 24 hours.
• 2. Cold Drink Timer: Start a timer to chill beverages.
• 3. Ice Maker: The ice maker produces ice until the bin is full. Press and hold "Ice Maker" for 3 seconds to turn it on or off.
• 4. Control Lock: Press and hold for 3 seconds to enable or disable the appliance control display. The indicator flashes, and an alert sounds when locked, preventing accidental changes.
• 5. Temperature Adjustment: Use the '+' or '-' buttons to set the desired temperature for the refrigerator or freezer compartment. The "Adjusting Temp" indicator lights up until the target temperature is reached.
• 6. Power Outage Alert: Illuminates and sounds an alert after a power outage ends, until any button is pressed to reset it.
• 7. Door Open Alert: Illuminates and sounds an alert if a door remains open for 5 or more minutes. Close the door to silence.
• 8. °F/°C: Switch between Fahrenheit (°F) and Celsius (°C) temperature displays.
• 9. Filter Status Indicators: "Replace Water Filter" or "Replace Air Filters" illuminate when it's time to change filters, typically every 6 months.
• 10. Chill Boost: Recommended before grocery shopping to cool food faster.

Side Door Dispenser Control Display

This display offers additional control options:

• 1. Control Lock: Press and hold for 3 seconds to enable/disable the display. The indicator flashes and an alert sounds when locked.
• 2. Temperature Selection: Select either "FREEZER" or "REFRIGERATOR" to adjust compartment temperatures using the '+' or '-' buttons. The unit is designed for 37°F (3°C) refrigerator and 0°F (-18°C) freezer, with stabilization expected within 24 hours. Freezer temperature range: -6°F to +6°F (-21°C to -15°C). Refrigerator temperature range: +34°F to +44°F (+1°C to +7°C).
• 3. Clear Alerts: Resets active alarms like "Door Open," "High Temp," or "Power Outage."
• 4. Freeze Boost: Activate before grocery shopping to lower temperatures and freeze food faster. Remains active for up to 24 hours.
• 5. °F/°C: Switch between Fahrenheit (°F) and Celsius (°C) displays.
• 6. Water Dispenser Enable: Press and hold for 3 seconds to enable or disable the water dispenser. LEDs above the dispenser illuminate when enabled.
• 7. Default Settings: Press and hold for 3 seconds to reset all settings to factory defaults.
• 8. Filter Reset: Press and hold "Water Filter" or "Air Filters" for 3 seconds after replacing the respective filter to reset the indicator.

Keep It Fresh

Frigidaire PureAir® AF-2™ Replacement Refrigerator Air Filter

This filter is more powerful than baking soda, absorbing undesirable smells and keeping your fridge fresher for up to 6 months. It's located at the top center of the refrigerator compartment.

To Change Your Filter:

1. Remove the air filter cover by squeezing the top and bottom together and detaching it from the liner.
2. Remove and discard the old filter.
3. Unpack the new filter. Snap it into the filter cover, ensuring the open face (carbon media) points outward.
4. Replace the air filter cover by squeezing the sides and snapping it back into place.
5. To reset the filter status, press and hold "Air Filter" on the appliance control display for 3 seconds. The status will reset to "GOOD."

Frigidaire PurePour™ PWF-1™ Ice & Water Refrigerator Filter

This filter is certified to reduce contaminants, providing great-tasting water for up to 6 months. It's located at the top right side of the refrigerator compartment.

Priming the Water Supply System (Before First Use):

Note: Ensure "Water Dispenser" is enabled on SIDE DOOR DISPENSER models (LEDs above the button should be lit).

1. Hold a glass under the water nozzle for approximately 4 minutes to purge air from the system.
2. Continue dispensing at least one full gallon (3.6 L) of water and discard it.

Install Your New PureAir PK-2 Produce Keeper Plus™ Refill

These refills (2 included) help extend the life of your produce.

1. Remove the outer plastic wrapper from the packets.
2. Insert the unopened packets into the designated holder within the Crisper drawer.

For optimal results, replace your air and water filters every 6 months, and your Produce Keeper Plus refills every 12 months.

FAQs

My refrigerator is making unfamiliar sounds. Is this normal?

New, high-efficiency units may produce unfamiliar sounds that indicate normal operation. Refer to the "NORMAL OPERATING SOUNDS" section in your Use & Care Manual for more details.

How do I use the side door dispenser?

The side door dispenser is located in the left-hand refrigerator door. Hold the door with one hand while placing your glass under the nozzle. Push the paddle with your other hand or finger to dispense water. If your glass is too small to activate the paddle, use your finger.

Why does my refrigerator seem to run continuously?

Your refrigerator features a variable speed compressor designed to run 100% of the time, except during defrost cycles. It may run faster at times, such as after a defrost cycle.

How does my CrispSeal® Fresh Crisper work?

The crispers are designed to block dry air and slow produce aging by reducing ethylene gases, which accelerate ripening. They feature an automatic humidity control membrane and do not require settings. If the membrane becomes damaged or dirty, it can be washed with soap and water; ensure it is thoroughly dried before replacement. For more information, refer to the "TROUBLESHOOTING" section in your Use & Care Manual.

Let's Make It Official!

Register your multi-door refrigerator to become part of the Frigidaire family and discover additional benefits. Look for the Frigidaire Photoregister icon on your registration card or register via the Frigidaire App.

We Are Here For You

For questions, help, or service, scan the QR code for owner support or visit frigidaire.com or frigidaire.ca.